Install the Rechargeable Battery Pack into the Handset
Follow these steps before using your cordless handset:
• Make sure the handset is registered to main base unit.
• Fully charge the battery pack.
1 Press down on the handset battery case cover (use the finger indention
for a better grip) and slide the cover downward to remove.
2 Plug the battery pack connector (red & black wires) into the jack inside the battery compartment. (The connector notches fit into the grooves of the
jack only
battery compartment, and push the connector in until you hear a click.
3 Make sure you have a good connection by slightly pulling on the battery wires. If the connection is secure, the battery
jack will remain in place.
4 Place the battery case cover back on the handset by sliding it upwards until it clicks into place.
5 Place the handset in the charging cradle with the keypad facing forward.
•Use only the Uniden battery
supplied with your phone. Replacement batteries are also available through the Uniden Parts Department. (See page 2.)
• Recharge your handset on a regular basis by returning the handset to the charger after each phone call.
Rechargeable
Must Be Recycled or Disposed of Properly
– 3 –