Uniden TRU 8065, TRU8865 owner manual Changing the Digital Security Code, Find Handset

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and the base unit. Normally, setting the code is not necessary. In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code. To change the digital security code:

1.De-register all the handsets you have (see "De-register the Handset (Handset only)" on page 30).

2.Register the handsets by following the steps under "Register the Handset" on page 15.

Find Handset

To locate the handset, press find handset on the base when the phone is in standby mode. All registered handsets beep for 60 seconds, and Paging appears on the handset display. To cancel paging, press any key on the handset or find handset on the base.

note

If the battery pack is completely drained, the handset will not beep when paging.

w w w . u n i d e n . c o m A D D I T I O N A L I N F O R M A T I O N [ 5 8 ]

A D D I T I O N A L I N F O R M A T I O N