Uniden XC630, XC633 manual Using Your XC 630/633, Channel, Placing a call

Page 19

Using Your XC 630/633

Selecting Pulse or Tone Dialing (Available on Australian Models only)

Australian models can use either Pulse Dialing or Tone Dialing, depending on the local service. New Zealand models are Tone Dialing only.

To set the Tone or Pulse Dialing, place the TONE/PULSE switch on the Base Unit in the proper position.

The tone pulse switch is situated underneath the bottom of the base unit. This switch has been disabled for the New Zealand models.

Placing a call

To place a call with your XC630/633;

]. Remove the Handset from the Base Unit and Press TALK.

2.Dial the number you are calling.

3.When you have finished the call, press TALK or return the Handset onto the Base Unit.

~

NOTE

Selecting

If you don't place the Handset back on the Base Unit, you will need to press TALK to hang up the phone.

a Channel

The CHANNEL button on the Handset allows you to choose among] 0 (AUS) or 25(NZ) factory set channels. If you are receiving any interference on a channel, press the button to switch to another channel. If the noise persists, or if a double beep is heard, move closer to the base before pressing CHANNEL. If the noise or interference continues, refer to the section entitled "Trouble- shooting" in this manual. This function works only when the phone is in use.

~

NOTE

Changing channels when the operating environment is extremely noisy may result in failure in communication between the base and handset. As a result the handset may fail to respond to keys pressed. To restore handset operation, re-cradle it on the base for about 6 seconds.

]9

Image 19
Contents Uniden@ Page Precautions SPECIFICATI0 NS Warranty Important Safety Instructions Persons by the BATTERY, Read and Follow These Instructions Unpacking About your Cord less TelephoneRolling Digital Code Security XC630/633 FeaturesUSE LED Charge LED Base Unit Controls & FunctionsHandset Control & Functions TalkChannel Most electronic key phone systems Read This before InstallationOverview Connecting the Telephone Line Installing Your Cordless TelephoneSelecting the Installation Location 9VDC Input Jack Installing the Telephone on a Desk or TabletopMounting the Telephone on a Wall Black Wire Installing the Battery PackCharging the Battery Pack Cleaning the Battery Contacts Low Battery IndicatorChannel Using Your XC 630/633Placing a call Using the Redial Button Using the Mute ButtonUsing the Flash Button Setting the Handset Receiver VolumeAnswering a Call Storing a NumberExample Storing Long Numbers in MemoryDialing a stored Number Using the Page/Find FeatureOptional Accessories Troubleshooting Operating Range Important Electrical ConsiderationsMore than One Cordless Telephone KaClO InterferenceSpecifications Warranty Procedure for Obtaining Performance of Warranty @ 1887UnidunCorporationADrightsrusurvud