If you lose a call after
changing channels.
Numbers stored in
memory cannot be dialed.
Phoneseemsdead?
Power off and on again.
If you are unable to turn the handset
ON/OFF, or if the base consistently fails to respond to the keys
being pressed.
.
.
.
.
.
.
.
.
You were probably almost out of range. Move closer to the base before changing channels. Before placing the call again,
place the handset on the base for at least 6 seconds.
The numbers stored in memory may have been lost due to a power down condition. In this case, you will have to reprogram the numbers into memory.
Remove the Handset from Base Unit (if is on the Base Unit).
Remove the Handset battery for 5 minutes. Unplug the Base Unit from the main power supply for a 5 minutes.
Reinstall the battery to the handset. Restore power to the Base Unit.
Place the Handset back on the Base Unit.
Important Electrical Considerations
Unplugall electrical appiiances when you know an electrical storm is
approaching. Lightning can pass through your household wiring and damage any device connected to it. The XC630/633 is no exception. Note: Please do not attempt to unplug any appliance during an electrical storm.
Operating Range
Your handset and the base station can communicate over a certain range. For clearest reception, keep the base and Handset antenna fully extended when using your handset away from the base.
Do make a few trial calls in and around your home or office to get a feel for the operating range in your particular surroundings.
~
NOTE
If you receive a call while you are out of range, the handset may not ring. Even if it does ring, the call may not connect when you press the TALK button. To receive the call, move
closer to the base before you press the TALK button again.
26