Installing the Belt Clip
Line up the tabs with the holes on each side of the handset. Press the belt clip down until both tabs click into place.
To remove the belt clip, pull both sides of the clip to release the tabs from the holes.
Installing the Optional Headset
Your phone may be used with an optional headset. To use a headset, insert the headset plug into the headset jack. Headsets may be purchased by calling the Uniden Parts Department. See inside the back cover page for contact information.
Charging the Accessory Handset
The handset is powered by a rechargeable battery pack that automatically recharges when the handset is placed in the charger.
) Connect the AC adapter to the DC IN 9V jack and to a 120V AC outlet that is not controlled by a wall switch.
Caution: Use only the Uniden
2) Set the charger on a | Route the cord. | |
desk or tabletop, and | ||
place the handset in the |
|
|
charger with the keypad |
|
|
facing forward. |
|
|
3) Make sure that the |
|
|
charge LED illuminates. |
|
|
If the LED does not | To AC outlet | To DC IN 9V |
illuminate, check to see |
|
|
that the AC adapter |
|
|
is plugged in and | AC adapter (supplied) | |
the handset makes | Caution: Use only the Uniden | |
good contact with the | ||
charging contacts on the charger.
4)Charge the handset battery pack for at least