Installing the Base and Charger
Note: Use only the supplied
1 | Connect each AC adapter to the DC IN 9V jack and |
to a standard 120V AC wall outlet. |
Route the cord.
To AC outlet
To AC outlet
AC adapter
(supplied)
To DC IN 9V
To DC IN 9V
Do not use a power outlet controlled by a wall switch.
AC adapter (supplied)
2 | Make sure that |
| the in use/ and |
| LEDs illuminate. |
Charge the handsets at least
If the LED does not illuminate, check to see that the AC adapter is plugged in and that the handset makes good contact with the charging contacts.
Once the handset
3battery packs are fully charged, use the telephone cord
to connect the TEL LINE jack to a telephone wall jack.
To telephone wall jack
Telephone cord (supplied)
Route the cord.
To TEL LINE
Charge both handsets at least 15 to 20 hours before you plug in the phone cord.
Note:
•Do not place the power cord where it creates a trip hazard or where it could become chafed and create a fire or electrical hazard.
•If the telephone cord does not fit into your telephone wall jack, contact your local phone provider for assistance.
Registering Handsets to the Base
Whichever handset you choose to charge in the base is automatically registered to the base. Any additional handsets must also be registered to the base before you can use them.
) Be sure both handsets are fully charged.
2)One at a time, place each handset in the base. The in use/
LED on the base begins to flash, indicating the base is registering the handset.
3)Wait for at least five seconds, then pick up the handset and press [talk/flash]. If the display shows TALK, the handset is registered. If not, place the handset in the base to try again.
4)Press [end] and continue with the next handset.
Note:
•Once both handsets are registered, it doesn’t matter which handset is placed in the base or the charger.
• When you charge the handsets, the | HS1 |
Caller ID summary screen and the |
|
name of the handset appears. | Total:00 |
Mounting the Base on a Wall
You can mount the phone on any standard telephone jack wall plate. ) Plug the AC adapter to the DC IN 9V jack.
2) | Plug the AC adapter into a standard 120V AC outlet. | 4 | |
3) | Plug the telephone cord into the TEL LINE jack. | ||
|
4) | Route the telephone cord through the molded | 6 |
| |
| wiring channel as shown. |
| 1 | |
) | Plug the telephone cord into the telephone | 5 | ||
3 | ||||
| wall jack. |
| ||
| 6 |
| ||
) | Align the mounting slots on the base with |
| ||
|
| |||
| the mounting posts on the wall. Then push in and |
|
| |
| down until the phone is firmly seated. |
| 2 |
Note: To mount the phone directly on the wall, insert two 1 3/8 inch, #10 screws (not supplied) into the wall using anchors suitable for the wall material. Place the screws 3 15/16 inches apart, and allow 1/8 inch free space between the wall and screw heads.