Uniden DECT1905 manual Handset registration

Handset registration

!compatible base (DECT 1915 or DECT1955 series base) before use.You must register the DECT 1905 handset to a

To check whether a handset is already registered, make sure mains power to the base unit is switched on and the handset is within range. The handset’s display should show its name (default Handset )and number. If the display constantly shows No base found, you need to register the handset.

	Each handset can be registered to up to four base
	units, which have numbers 1 to 4.
To re-register 1	find hs On the base unit, press and hold the
or to register a		FIND HS button until you hear
new handset		Registration tone (repeated ‘beeps’)
		You now have 60 seconds to register the
		handset.
2		On the handset, press the right Soft button
		[Menu], then press the ￿ or ￿ button to
		scroll to Handset
3		Press the right Soft button [OK]
4		Press the ￿ or ￿ button to scroll to Register,
		then press the right Soft button [OK]

uThe display shows a list of base units. If any of these numbers has a tick next to it, the handset is already registered to that base unit.

5	Move the highlight to BASE: 1 then press the
	right Soft button [OK]

uThe display shows Base-PIN:

6Key in the base unit’s PIN code (default 0000)

If the base unit’s PIN code has been changed from 0000 (see your base unit's User Guide), you’ll need to know the current PIN code.

7