Install the Battery Pack, Battery Information

Install the Battery Pack

Charge the battery pack for at least 15-20 hours before completing the installation or using the handset.

1 Press down on the battery cover release and slide the cover down until it comes off.

2 Connect the battery pack connector observing the correct polarity (black and red wires) to the jack inside the battery compartment.

Do not exert any force on this connection. It could cause damage to the battery or to the handset. The plastic connectors will fit in only one way.

Once you are certain that you have made a good connection, then insert the battery pack into the battery compartment. Do not pinch the wires.

3 Securely close the battery compartment cover by sliding it until it snaps into place.

4 Place the handset in the charging cradle with the keypad facing forward.

• Use only the Uniden battery (BT-446) supplied with your phone. Replacement batteries are also available through the Service Division (See page 1).

• Recharge your handset on a regular basis by returning the handset to the charger after each phone call.

From fully charged (15-20 hours charge time)

•Up to 4 hours continuous use

•Up to 8 days when the handset is in the standby mode

– 2 –