Uniden EXA 7950 manual Wall Installation, Standard wall plate mounting, VAC wall outlet

Page 6

HINT

Before using your phone, fully charge the Nickel- Cadmium battery pack for 15-20 hours.

CAUTION

Place the power cord so that it does not create a trip hazard or where it could become chafed and create a fire or electrical hazard.

7) Set the base on a desk or tabletop, and place the handset into the base

as shown. Then, raise the antenna to a vertical position.

WALL INSTALLATION

▼Standard wall plate mounting

This phone can be mounted on any standard AT&T or GTE wall plate.

1) Slide the wall mount adapter into the notches at the top of the base.

2) Rotate the wall mount adapter down and snap it into place at the bottom of the base.

3)Plug the AC adapter into the base.

4)Put the AC adapter cord inside the

molded wiring channel, then wrap it around the strain relief notch. Plug the AC adapter into a standard

120 VAC wall outlet.

4

Page 5 Page 7
Image 6
Page 5 Page 7
Contents
Page Installing and Adjusting Your Phone N T E N T SFeatures WelcomeRechargeable Battery Included in Your PackageHandset Base Wrap the AC adapter cord around the strain relief notch DESK/TABLETOP InstallationCharge the battery refer to Charging the Battery Pack, Plug the AC adapter into a standard 120 VAC wall outletWall Installation Standard wall plate mountingVAC wall outlet Install I N G a N D a D J U S T I N G Direct wall mounting VAC wall outlet Installing the Handset Battery Pack Charging the Battery PackInitial battery charging Cleaning the Battery Contacts Low battery indicatorFor 60 seconds Handset ringer tone and ringer volume Setting the PULSE/TONE SwitchAdjusting the Ringer Controls Handset earpiece volumeAutomatic Digital Code Security Making and Receiving Calls Flash and Call WaitingDialing a Stored Number Using the memory location featuresStoring a Phone Number in Memory Remove the handset from the baseErasing a Stored Number from Memory Dial the party or service main numberChain Dialing One-touch priority dialingTone Using the SpeakerphoneRedial Traveling OUT-OF-RANGEUpsetting Integrated Answering DeviceSetting the Clock Turning the Answering System ON/OFFFollowing message is prerecorded Preset messageRecording your personal greeting To record your own greeting, follow the steps belowFour minute option move the REC Time switch to Announce only featureWhen the system is on standby Selecting the Message Record TimeCalling Party Control Feature Selecting a PIN CodeSetting the Toll Saver Switch Using the Reset ButtonYou can set the switch to answer Playing Your Messages Repeating a MessagePress play/stop. The system Skipping a Message E U S EDeleting a Message Voice MemoPress play/stop to review your messages Remote Access Away from Home Recording a ConversationTo stop recording, press play stop or voice memo again Function Press Remote Room Monitor Quick Reference Chart Not work After a power failure, Record your personal outgoingHandset doesn’t ring or Turned onAnother phone to access It cannot, you may have to useYour messages S E Talk mode Hours Standby mode DaysN E R a L N D S E TAt Uniden, we’ll take care of you Functionsand Controls Thankfor
Top Page Image Contents