Uniden EXS 2060 manual Direct wall plate mounting

If the handset beltclip is attached, you cannot charge the handset facing forward when the phone is mounted on the wall. (See page 36.)

9

8 On the base unit, pull the handset retainer out of the slot. Rotate it clockwise 180 degrees.

9 Flip the retainer from front to back. Slide it back into the slot so that the lip of the retainer is up and the oval is down. The retainer holds the handset

in place.

Direct wall plate mounting

If you don't have a standard wall plate, you can mount your phone directly to the wall. Before doing this, consider the following:

•Avoid electrical cables, pipes, or other items behind the mounting location, that could cause a hazard when inserting screws into the wall.

•Try to mount your phone within 10 - 15 feet of a working phone jack to avoid excessive cord lengths.

•Make sure the wall material is capable of supporting the weight of the base and handset.

•Use #10 screws (minimum length of 1-3/8 inches) with anchoring devices suitable for the wall material where the base unit will be placed.

1 Insert two mounting screws into the wall, (with their appropriate anchoring device), 3-15/16 inches apart. Allow about 3/16 of an inch between the wall and screwheads for mounting the phone.

2 Refer to steps 1 through 9 on page 8 and 9 to mount the telephone.