Installing the Battery
Follow the steps below to install the rechargeable battery pack.
1. Using the finger indentation, press in on the battery case cover and slide it down to remove it.
2. Plug the battery connector into the battery compartment jack. Be sure to match the red and black wires to the label near the jack.
3. Gently pull on the battery wires. If the battery connector comes loose, try connecting it again.
4. Replace the battery case cover and slide it up until it clicks into place.
Note: Use only the Uniden
Installing the Belt Clip
Line up the tabs with the holes on each side of the handset. Press the belt clip down until both tabs click into place.
To remove the belt clip, pull both sides of the clip to release the tabs from the holes.
Installing the Optional Headset
Your phone may be used with an optional headset. To use a headset, insert the headset plug into the headset jack. Headsets may be purchased by calling the Uniden Parts Department. See back cover page for contact information.
3