Preparing the Battery Pack
Charge the battery pack for at least
1 | Press in on the battery cover release and slide the | 2 |
| cover down until it comes off. |
|
2 | Connect the battery pack connector with the correct | 1 |
| ||
| polarity (black and red wires), then insert the |
|
| battery pack into the battery compartment. |
|
3 | Securely close the battery compartment cover by | 3 |
| sliding it up until it snaps into place. |
|
4 | Place the handset on the base as shown. | 4, 5 |
|
|
5 Make sure that the status LED lights. If the LED doesn´t light, check to see that the AC adapter is plugged in and that the handset makes good contact with the base charging contacts.
Use only the Uniden Battery |
|
with your phone. Replacement batteries are also | status LED |
available through the Uniden Parts Department. | |
(see page 5) |
|
The plastic connectors will fit together only one way. Make sure the battery´s connector is properly aligned.
GETTING STARTED
G E T T I N G S TA R T E D [ 9 ]