Uniden WXI377 manual Activate the handset before charging the battery, Getting Started

Page 9

B. Activate the handset before charging the battery

The handset is powered by a rechargeable battery pack already installed in the handset’s battery compartment. Before charging the battery for the fist time, push the pin for activation, located on the bottom of the handset (see label with instructions). Once activated, remove the label and then place the handset in the base unit to charge.

Make sure to charge for 15-20 hours without interruption (do not plug the telephone cord into the unit and wall jack during charge time). The base unit’s LED light labeled (charge/in use) illuminates once the handset is placed in the base. The LED light will illuminate regardless if the battery pack is connected or not.

If the base charge/in use LED light does not illuminate:

•Check to see if the AC adapter is plugged into the base unit and the electrical wall outlet properly. (Use only the supplied AC adapter. Do not use any other AC adapter.)

•Check to see if the handset is sitting correctly in the base.

www.uniden.com

• Use only the Uniden (BT-909) rechargeable battery pack supplied with your cordless telephone.

• Replacement batteries and/or rubber seals are also available through the Uniden Parts Department at (800) 554-3988, Monday thru Friday from 8:00 a.m. to 5:00 p.m. or online at www.uniden.com

G E T T I N G S TA R T E D [ 9 ]

GETTING STARTED

Image 9

Contents Page Page Base unit HandsetTelephone cord Contents Welcome FeaturesControls and Functions N T R O L S a N D F U N C T I O N S Choose the best location Setting up the PhoneDo the following steps Avoid microwave ovensGetting Started Activate the handset before charging the batteryReplace the rechargeable handset battery pack Low battery alert Battery use time per chargeTalk Mode Standby ModeAC adapter Connect the base unitStandard wall plate mounting Mounting the Base Unit on a WallDirect wall mounting Caller ID options Setting Menu OptionsEntering Your Area Code Choosing the dialing mode Setting the language Handset On Base Handset Off Base Making and Receiving CallsHandset ringer tone and volume Adjusting the Handset Ringer and Earpiece VolumeEarpiece volume RedialTraveling Out-of-Range Tone Dialing Switch-overFlash and Call Waiting Selecting a Different ChannelMemory Dialing Storing Phone Numbers and NamesE M O R Y D I a L I N G If you make a mistake while entering a name Steps for Entering Names and Special CharactersMemory dialing from Standby Mode Memory dialing from Talk ModeMaking Calls with Memory Dialing Editing a Stored Name and/or Phone Number Chain DialingCursor flashes indicating that the display is ready for Press select or delete/ch Erasing a Stored Name and Phone NumberRocketDial Storing and Editing the RocketDialMaking Calls with the RocketDial C K E T D I a L Deleting the RocketDialWhen the Telephone Rings You must subscribe to Caller ID service to use this featureCaller ID Press cid/menu Viewing the Caller ID Message ListWhen the pointer is at No When the pointer is at YesDeleting Information from the Caller ID List Deleting a Caller ID messageUsing the Caller ID List Long Distance calls and Area Code Setting/CancellationCalling a party from the Caller ID list Storing Caller ID messages in Memory dialing Changing the Digital Security Code Installing the BeltclipTo attach the beltclip To remove the beltclipBattery replacement and handling MaintenancePower Failure When the handset or base unit becomes slightly dirtySymptom Suggestion Charge/in use LED wont TroubleshootingSymptom Suggestion Case Action Liquid DamageBattery Information General InformationAC Adapter Information Precautions Important Safety InstructionsImportant Electrical Considerations One Year Limited Warranty Installation ConsiderationsTerminal Equipment Radio Equipment G, H At Uniden, we´ll take care of you