Uniden WXI377 manual Connect the base unit, AC adapter

Page 12

•The base is not water resistant. Also wipe off a dirty or wet handset before placing in the base.

•Use only the supplied AD-0002 AC adapter. Do not use any other

AC adapter.

•Place the power cord so that it does not create a trip hazard or where it could become chafed and create a fire or electrical hazard.

C. Connect the base unit

Route the cord.

1) Connect the AC adapter to the DC IN 9V jack and to a standard 120V AC wall outlet.

2) Set the base on a desk or tabletop, and place the handset in the base unit.

3)Make sure that the charge/in use LED illuminates.

If the LED does not illuminate, check to see that the AC adapter is plugged in and that the handset is sitting correctly in the base.

•Connect the AC adapter to a continuous power supply.

•Place the base unit close to the AC outlet so that you can unplug the AC adapter easily.

•After activating the handset, charge your handset at least 15-20 hours before plugging into the phone line.

4) Once the handset battery pack is fully charged, connect the telephone line cord to the TEL LINE jack and to a telephone outlet.

If your telephone outlet isn't modular, contact your telephone company

for assistance.

Modular

[ 12 ] G E T T I N G S TA R T E D

www.uniden.com

Image 12

Contents Page Page Base unit HandsetTelephone cord Contents Features WelcomeControls and Functions N T R O L S a N D F U N C T I O N S Setting up the Phone Choose the best locationDo the following steps Avoid microwave ovens Activate the handset before charging the battery Getting StartedReplace the rechargeable handset battery pack Battery use time per charge Low battery alertTalk Mode Standby ModeConnect the base unit AC adapterMounting the Base Unit on a Wall Standard wall plate mountingDirect wall mounting Setting Menu Options Caller ID optionsEntering Your Area Code Choosing the dialing mode Setting the language Making and Receiving Calls Handset On Base Handset Off BaseAdjusting the Handset Ringer and Earpiece Volume Handset ringer tone and volumeEarpiece volume RedialTone Dialing Switch-over Traveling Out-of-RangeSelecting a Different Channel Flash and Call WaitingStoring Phone Numbers and Names Memory DialingE M O R Y D I a L I N G Steps for Entering Names and Special Characters If you make a mistake while entering a nameMemory dialing from Standby Mode Memory dialing from Talk ModeMaking Calls with Memory Dialing Chain Dialing Editing a Stored Name and/or Phone NumberCursor flashes indicating that the display is ready for Erasing a Stored Name and Phone Number Press select or delete/chRocketDial Storing and Editing the RocketDialMaking Calls with the RocketDial Deleting the RocketDial C K E T D I a LWhen the Telephone Rings You must subscribe to Caller ID service to use this featureCaller ID Viewing the Caller ID Message List Press cid/menuWhen the pointer is at Yes When the pointer is at NoDeleting Information from the Caller ID List Deleting a Caller ID messageUsing the Caller ID List Long Distance calls and Area Code Setting/CancellationCalling a party from the Caller ID list Storing Caller ID messages in Memory dialing Installing the Beltclip Changing the Digital Security CodeTo attach the beltclip To remove the beltclipMaintenance Battery replacement and handlingPower Failure When the handset or base unit becomes slightly dirtyTroubleshooting Symptom Suggestion Charge/in use LED wontSymptom Suggestion Liquid Damage Case ActionBattery Information General InformationAC Adapter Information Precautions Important Safety InstructionsImportant Electrical Considerations Installation Considerations One Year Limited WarrantyTerminal Equipment Radio Equipment G, H At Uniden, we´ll take care of you