Warranty 1 Year, Limited, RF Exposure Information

xx Increase the separation between the equipment and receiver.

xx Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

xx Consult the dealer or an experienced radio/ TV technician for help.

RF Exposure Information

This product complies with FCC radiation exposure limits under the following conditions:

xx The base must be placed to allow a minimum of 20 cm (8 inches) between the antenna and all persons during normal operation.

xx The base must not be collocated or operated in conjunction with any other antenna or transmitter.

xx The handset is designed for body-worn operation and meets FCC RF exposure guidelines when used with any belt clip, carrying case, or other accessory supplied with this product. (All necessary accessories are included in the package; any additional or optional accessories are not required for compliance with the guidelines.) Third party accessories (unless approved by the manufacturer) should be avoided as these might not comply with FCC RF exposure guidelines.

Disable All Functions Except Charging

D1481/D1483 Base

1.Press and hold SKIP and VOL + simultaneously, then plug in the AC adapter.

2.Continue to hold the keys for about 5 seconds. When the message counter turns off, all functions are disabled except for charging.

D1481/D1483 Handset

1.Install the battery.

2.When the “Welcome, please wait...” message disappears from the display, press and hold END, MENU, and * simultaneously.

3.After about 5 seconds, a confirmation tone sounds, indication all functions except charging are disabled.

To return to normal operation, cycle the power for the base and remove and reinstall the handset battery.

Industry Canada (I.C.) Notice

Terminal equipment

NOTICE: This equipment meets the applicable Industry Canada Terminal Equipment Technical Specifications. This is confirmed by the registration number. The abbreviation IC before the registration number signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. It does not imply that Industry Canada approved the equipment.

NOTICE: The Ringer Equivalence Number (REN) for this terminal equipment is marked on the equipment itself. The REN assigned to each terminal equipment provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed 5.

Radio equipment

The term IC before the radio certification number only signifies that Industry Canada technical specifications were met. Operation is subject to the following two conditions:

(1)this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. "Privacy of communications may not be ensured when using this telephone."