Panasonic RX-D11 operating instructions Listening to radio broadcasts

Page 9

L

2 1 3 4

Listening to radio broadcasts

Listening to broadcast stations which have not been programmed (Manual tuning)

Preparation: Set [] to “TUNER”.

1

Press [BAND] to select “FM” or “AM”.

Every time you press the button: FM AM

 

 

Press [TUNE MODE] to clear the preset indicator.

2

 

The unit is set to the manual tuning mode.

 

Press [–/g] or [f/+] to tune in the station.

3

 

Adjust the volume.

4

1

2

3

4

2

3

1 2

3

1

MEMORY/

PGM

Indicates auto scan

RX-D11 only

When using the remote control

1.Press [BAND] to select “FM” or “AM”.

2.Press [–/g] or [f/+] to tune in the station.

Automatic tuning:

This is a simple way of tuning in stations that have not been preset. Keep [–/g] or [f/+] depressed, and release it when the frequency display starts to change. A station with good reception is automatically selected and the selection process then stops.

To stop automatic tuning, press [–/g] or [f/+] again.

Hint

Automatic tuning may stop without a station having been tuned in when interference is encountered on neighbouring airwaves. In such a case, tune in a station by tapping [–/g] or [f/+].

Using auto scan RX-D11 only

You can search for a station by listening to all tuned-in stations for 8 seconds each.

Preparation: Set [

] to “TUNER”.

(Only from the remote control)

Press [BAND] to select “FM” or “AM”.

Press [AUTO SCAN].

Auto scan starts.

Press [AUTO SCAN] when you find the desired station.

Auto scan ends when it reaches the original frequency again. To stop during the process, press [AUTO SCAN].

To turn off the unit:

Set [] to “TAPE/”.

If the tape is travelling, press [L/c STOP/EJECT] as well.

Adjusting the antennas A

For FM reception:

Pull out the telescopic antenna and adjust its length and angle for optimum reception.

For AM reception:

Turn the unit in the direction which gives the best results.

Reference

Radio broadcasts may be hard to receive in a moving vehicle or in a building because the signal may be weakened. In such cases, use the unit near a window.

When there is a lot of noise in an FM stereo broadcast

Listening

A FM

AM

Reduce the interference by setting the sound to monaural.

Example:

When an FM stereo program is being received;

Press [FM MODE].

MONO ” is displayed.

To return to stereo reception, repeat the same procedure to turn off the “MONO ” display.

9

RQT5210

Image 9
Contents Portable Stereo CD System Table of Contents Supplied accessoriesDear customer Figure B Figure aPrecautions a Power sourcesBeforeuse B Location of controls Power sourcesMemory back-up batteries not included Before useTo listen through headphones not Included D Concerning the remote controlUse Before Location of controlsListening Presetting radio broadcastsSet To Tuner Press Band to select FM or AM Press MemoryListening to radio broadcasts Listening to programmed stations Preset a tuningListening to radio broadcasts Listening to CDs Sequential playRepeat play and random play Program play Listening to CDsPress L Clear Press -/ g or f/ + to select the desired trackListening to tapes Adjusting the deep-bass XBSChanging the sound quality Press XBS to boost the bass soundsRecording from radio broadcasts B Before recordingRecording from CDs C RecordingConcerning CDs Concerning cassette tapesReference Maintenance Troubleshooting guideFor a cleaner crisper sound If the surfaces are dirtyTechnical specifications