Hasbro 02015 user manual Downloaderl Instruction, Getting Started

Downloaderl

Instructioni	Ages 5 & Up
	Item No. 02015

For more details on using

your Yahoo! HitClips Downloader,

visit www.tigertoys.com and

click on the icon.

Removable/Recordable

HitClip Chip

Stop

Button Record

Button

Personal

Headphone

JackBuilt-in

Speaker

Audio

Pass-Through

Jack

Play Button

Docking Station

Diagram 1

3.5mm Audio Input Plug

Getting Started

Your new Yahoo! HitClips Downloader can record sounds and music right off of your computer and the internet without any special software, or use of a Comm Port. It plugs right into your external speaker or headphone output jack.

1.Install batteries as described below.

2.Plug the built-in input plug into your computer' s external speaker or headphone jack. If you have trouble finding this jack, check the user manual for your computer.

Diagram 2

3.In order to continue to hear music, you must now attach your external speakers or headphones to the Pass-through jack located on the HitClips Downloader's docking station (See Diagram 3)

Note # 1: If you do not plug external speakers or headphones into the Pass-through jack you will NOT be able to hear what you are recording or the sound from your computer.

Note # 2: Once the docking station is set up, you can leave it attached to your computer as well as leave the external speakers attached to the Pass-through jack.

Note # 3: Pass-through function is only to monitor sounds. Not to indicate recorded sound level.

Note # 4: If you do not have external speakers or headphones you can still use the HitClips Downloader, but you will not be able to hear the sounds at the same time as you are recording (Refer to the section on How to Record).

Diagram 3

4.Place HitClips Recordable Chip into Player as shown in Diagram 4.

5.Place the Player unit into the docking station.

Diagram 4

Recording onto your

HitClips Recordable Chip

1.Place the Recordable Chip into the Downloader.

2.Make sure that all cables are attached as described above

3.Depress the REC button located on the Recordable chip. (See Diagram 1)

4.The red light in the middle of the Chip will start to blink on and off. This indicates that the Downloader is ready to record.

Note: The Yahoo! HitClips Downloader will record almost any sound that can be played or heard through the speakers of your computer, provided they are played at a high enough volume level. (See section 6)

5.Play the sounds or music on your computer as you would normally do.

6.The HitClips Downloader will automatically start recording when it senses sound being passed through the system.

Note # 1: Before recording, set your computer's output volume at about 50% of full.

Note # 2: If the Downloader does NOT start recording, try turning the output volume, on your computer, up until it is at a level that activates recording.

Note # 3: Playback sound volume will vary depending upon the output volume on your computer.

Note # 4: By changing your computer's output volume, you can change the way your recording sounds. You can experiment by adjusting the output volume during recording then playing back your recording on the player.

7.You will know you are recording when the blinking light stops blinking and stays on bright red. The Recordable Chip that comes with the Downloader will record for approximately 2 minutes. Time may vary depending on sound quality and complexity of the sounds being recorded.

a.You can monitor what you are recording if you have attached external speakers or headphones to the Pass-through jack on the docking station.

b.If you do not attach speakers or headphones, you will not be able to hear the sounds that you are recording.

8.When the Red Light on the Recordable Chip goes off, the recording has stopped.

9.You can stop recording manually by depressing the STOP button on the Recordable chip. (See Diagram 1)

10.Your Recordable Chip can be used over and over again.