Morphy Richards 28026 operating instructions Radio controlled clock automatic clock operation

3Press the mode button (8) 6 times. The unit will be at world time setting mode. Choose the city you want to review, e.g. LAX Los Angeles. Press the Snooze button

(7) once. The DST symbol will appear. One hour will be added onto the world time. Please note that this action will only affect that particular time zone, i.e. LAX time. It will not change your local real time, i.e. LON.

Battery back-up facility (unit will work without a battery being fitted)

1Remove the battery compartment cover (located underneath the unit) by pushing in the clip and lifting off.

2Insert a 2 x AAA batteries and connect to terminals (Ensure batteries are inserted correctly)

3Replace the battery compartment cover.

Should a power interruption occur the clock will continue to run, however, time keeping will not be accurate.

If the optional battery is not installed in case of the AC power failure, the clock will go through the automatic msf setting. You will need to reset the alarm when power is restored.

Battery back-up is designed to operate for a short period only.

If the unit is not to be used for a prolonged period, remove the battery to avoid battery leakage.

In the interests of environmental safety : dispose of batteries safely.

Radio controlled clock (automatic clock) operation

Once you plug in the power cable and install the back-up batteries in the battery compartment (2).

1All the segments go solid for 2 seconds (LCD panel back-light will come on automatically).

2 The letters “LON” and the rc signal receiver symbol will flash.

3After a few seconds the display will show “— : — “ with the second section “00”.

4When the RC signal has been received and decoded successfully, the second section starts counting up. The real time clock is updated by the signal which goes solid and immediately switches to the Auto Run Mode.

4