Clock operation operate without RC signal

If the RC signal has not been received and decoded successfully

1Your unit will stay in “0:00” with all the symbols cleared and will stop receiving the RC signal after 15 minutes.

2Press the mode button (8) once to switch the unit into self quartz oscillation Auto Run Mode. Please refer to the SETTING THE TIME AND DATE IN REAL TIME SECTION to set the clock manually. (The date and time is defaulted to 2 January 2003 0:00).

3If you wish to receive the RC signal again, press the RC signal receiving mode button (14) to start receiving the signal.

Press the RC signal receiving button (14) to change the RC signal receiving mode accordingly.

1When the symbol flashes you will start receiving the RC signal

2When the symbol clears your unit will start receiving the RC signal at 0:00 or 12:00 only.

NOTE:

a)In order to get a clear, accurate RC signal, your clock requires several minutes for receiving. This is normal.

b)Please do not place the RC signal receiver (1) near any electronic or electrical products to avoid any interference (e.g. TV set, computer, refrigerator etc).

Clock operation (operate without RC signal)

Your clock is designed to operate by either synchronizing with the RC signal or built-in quartz oscillation, which means your clock can always be working even after you have left the RC signal transmitting area.

Weak or no RC signal is detected:

When there is a weak RC signal (not enough for synchronizing), the “0:00” will appear. Please set the clock manually. (Please refer to the clock setting section).