PYLE Audio PICD65I user service Electronic Volume Control, Operation of Radio

Page 5
NEXT/ TUNE + OR

ELECTRONIC VOLUME CONTROL

-THIS UNIT USES AN ELECTRONIC VOLUME CONTROL (PUSH BUTTON TYPE) .

-TO INCREASE OR DECREASE THE LOUDNESS OF UNIT, PRESS

THE VOLUME UP (VOL +) OR VOLUME DOWN (VOL -) KEYS RESPECTIVELY.

-RELEASE THE KEY WHEN VOLUME LEVEL IS AT THE DESIRED LOUDNESS.

-SOMETIMES, ESPECIALLY DURING LISTENING TO THE RADIO, YOU MAY NOTICE A "CLICK-CLICK-CLICK" (REPEATING) SOUND WHEN YOU ARE INCREASING OR DECREASING THE VOLUME. THIS IS A NORMAL CONDITION & THE SOUND WILL DISAPPEAR WHEN YOU RELEASE THE VOLUME KEY (WHEN YOU REACH THE DESIRED VOLUME LEVEL).

OPERATION OF RADIO

-PRESS THE "ON/OFF" KEY ONCE TO SWITCH ON THE UNIT.

-PRESS THE FUNCTION KEY (ON UNIT) REPEATEDLY UNTIL THE DISPLAY SHOWS "FM" OR PRESS THE "TUNER" KEY ONCE ON REMOTE CONTROL.

-TO IMPROVE FM-RADIO RECEPTION, FULLY EXTEND THE FM-ANTENNA WIRE AND ADJUST IT'S POSITION.

-USE THE "FM MODE" KEY (ON REMOTE CONTROL) TO SELECT THE

DESIRED MODE (FM MONO/STEREO). IN SOME CASES, WHERE RECEPTION IS POOR, IT MAY BE ADVISABLE TO SELECT “MONO” MODE, TO IMPROVE CLARITY OF THE RADIO SIGNAL.

MANUAL FREQUENCY ADJUSTMENT (SCAN MODE)

-PRESS (AND IMMEDIATELY RELEASE) THE NEXT KEY OR BACK

KEY TO “SCAN” (MANUALLY ADJUST) THE RADIO FREQUENCY “UP” OR “DOWN” BY 1-STEP AT A TIME.

-THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY AT EACH STEP’S POSITION.

-WHEN A DESIRED FREQUENCY OR STATION IS REACHED. IT CAN BE SAVED INTO ONE OF THE “MEMORY” POSITIONS. (SEE “RADIO MEMORY” SECTION).

AUTOMATIC FREQUENCY ADJUSTMENT (SEEK MODE)

-PRESS AND HOLD (FOR 2 SECONDS) THE NEXT OR BACK KEYS

TO “SEEK” (AUTOMATICALLY ADJUST) THE RADIO FREQUENCY “UP” OR “DOWN” TO THE NEXT AVAILABLE RADIO STATION.

-THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY OF THE NEXT STATION THAT IS FOUND.

-WHEN A DESIRED STATION IS REACHED. IT CAN BE SAVED INTO ONE OF THE “MEMORY” POSITIONS. (SEE “RADIO MEMORY” SECTION).

RADIO MEMORY (STATION PRESET MEMORY STORAGE)

-AT ANY TIME, THE CURRENTLY DISPLAYED STATION OR FREQUENCY CAN BE STORED INTO ONE OF THE MEMORY POSITION.

-PRESS PROGRAM KEY ONCE.

-PRESS RADIO M+ OR RADIO M- KEY ON THE REMOTE CONTROL TO SELECT DESIRED MEMORY POSITION. (THERE ARE 30 MEMORY POSITIONS FOR FM BAND).

-PRESS PROGRAM KEY ONCE TO SAVE THE SELECTED STATION INTO THE SELECTED MEMORY POSITION.

- TO RECALL ANY SAVED MEMORY, SIMPLY PRESS RADIO M+ OR RADIO M- , THE SAVED RADIO-BAND WILL BE RECALLED.

-TO CLEAR THE MEMORY OF ANY POSITION, SIMPLY SAVE A NEW STATION TO THE SAME MEMORY POSITION.

E-9

OPERATION WITH THE iPod/ iPhone

THIS UNIT IS DESIGNED TO ALLOW YOU TO CONNECT AN iPod/ iPhone WITHOUT THE NEED FOR DOCK CONNECTORS. THE DESIGN OF THE UNIT HAS BEEN STRUCTURED

TO PROVIDE SUPPORT TO TE CONNECTOR UNDER NORMAL USAGE WITHOUT EXCESSIVE PRESSURE ON THE iPod/ iPhone WHEN CONTROLLING PLAYBACK USING THE iPod/ iPhone

SCREEN.

- TURN ON BOTH THE UNIT AND THE iPod/ iPhone.

- PRESS THE FUNCTION KEY REPEATEDLY UNTIL THE DISPLAY SHOWS “iPod”

OR SIMPLY PRESS THE "DOCK" KEY ON REMOTE CONTROL.

-THE UNIT WILL AUTOMATICALLY START PLAYBACK OF THE SONGS.

-THE iPod/ iPhone DISPLAY WILL INDICATE THE INFORMATION OF THE CURRENT SONG (TRACK).

-AT ANYTIME DURING PLAYBACK, PRESS THE PLAY/PAUSE KEY

TO PAUSE OPERATION OF THE UNIT. PRESS PLAY/PAUSE KEY TO RESUME OPERATION AT THE SAME TRACK & POSITION.

-AT ANYTIME DURING PLAYBACK, PRESS & HOLD THE PLAY/PAUSE KEY TO STOP PLAYBACK OF UNIT.

- AT ANYTIME DURING PLAYBACK, PRESS AND RELEASE THE

BACK/ TUNE - KEYS ON UNIT (OR "iPod NEXT/ iPod BACK" KEY ON REMOTE

CONTROL) TO SKIP FORWARD OR BACKWARDS BY ONE TRACK, AS DESIRED.

- ANY ANYTIME DURING PLAYBACK, PRESS AND HOLD THE

 

NEXT/ TUNE + OR

 

 

BACK/ TUNE - KEYS ON UNIT (OR "iPod NEXT/ iPod BACK" KEY ON REMOTE CONTROL) TO FAST-FORWARD (CUE) OR FAST-REVERSE (REVIEW)

THE SPECIFIC TRACK, WHICH IS CURRENTLY PLAYING.

-YOU CAN OPERATE THE iPod/ iPhone USING EITHER THE SET, REMOTE CONTROL OR DIRECTLY WITH THE iPod/ iPhone ITSELF.

-WHEN THE iPod/ iPhone HAS BEEN CONNECTED WITH THE UNIT, IT WILL START CHARGING THE BATTERY OF THE iPod/ iPhone.

-NEVER REMOVE (OR UNPLUG) THE iPod/ iPhone FROM THE SET DURING PLAYBACK, ALWAYS PRESS & HOLD FOR 2 SECONDS THE PLAY/PAUSE KEY FIRST AND THEN

PRESS THE FUNCTION KEY TO SWITCH TO ANOTHER SOURCE (EG. “RADIO” OR “AUX”) BEFORE REMOVING OR UNPLUGGING THE iPod/ iPhone,

TO PREVENT DAMAGE TO YOUR SONG FILES OR MEMORY DEVICES.

"Made for iPod," "Made for iPhone," mean that an electronic accessory has

been designed to connect specifically to iPod, iPhone, respectively, and has been certified

by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note that the use of this accessory with iPod, iPhone may affect wireless performance.

REPEAT PLAYBACK FUNCTION (iPod/ iPhone)

-AT ANYTIME DURING iPod/ iPhone PLAYBACK:

-PRESS THE "PLAY MODE" KEY ON REMOTE CONTROL OR

PRESS THE FOLLOWING SYMBOLS ON THE iPod/ iPhone SCREEN:

= TO REPEAT THE CURRENT TRACK

= TO REPEAT ALL TRACKS

E-10

Image 5
Contents Control RemoteDisplay See Figure Important Safety InstructionsImportant HOW to Tell if Power is on ? Remote Control Location of ControlsAutomatic Power OFF Sleep Function Automatic Power ON/OFF Timer FunctionHOW to SET Timer Digital Clock FunctionManual Frequency Adjustment Scan Mode Electronic Volume ControlAutomatic Frequency Adjustment Seek Mode Radio Memory Station Preset Memory StorageMusic Equalizer Insertion and Removal of DiscsNormal CD Operation Programming the CD-PLAYERSpecifications Using the Audio Line in Connection AUX-INPUTWall Mount SET UP Repeat Playback FunctionFixing the Base to the Unit System SET UP ProcedureModel PICD65I Pyle Manual Plan for Approval