Operating your radio - Search tuning FM
1.Fully extend the wire aerial and press the On/Off button to switch on your radio.
2.Press and release the Function button until the FM band is selected.
3.Press the Skip Up button and then press the Alarm/Auto scan button. Your radio will scan from the currently displayed frequency direction upwards and will stop scanning when it finds a station of sufficient strength.
4.The display will show the frequency of the signal which has been found. If RDS information is available, after a few seconds the display will show the radio station name. The display will also show "St" and "RDS" on the upper line if the station is received with stereo and RDS information.
5.To find other stations press and hold the Alarm/Autoscan button as above.
6.To scan the FM band in a downwards direction (high frequency to low frequency) press the Skip Down button and then press Alarm/Auto scan button.
7.When the end of the waveband is reached your radio will recommence tuning from the opposite end of the waveband.
8.Adjust the Volume to the required settings.
9.To switch off your radio press the On/Off button.
1
2
6 3 3,6
8 8
9
15