Roberts Radio CR9935 Operating your radio manual tuning

Page 13

Operating your radio - manual tuning

1.Switch on your radio by pressing the On/Off button.

2.Select the required waveband by pressing the Band button. The waveband selected will appear in the display. On FM fully extend the pigtail aerial from the rear of your clock radio. On MW rotate your radio for best reception.

3.A single press on either the Tuning Up or Down buttons will change the frequency up or down. The frequency steps are:- FM 50kHz and MW 9kHz.

4.Adjust the Volume control to the required level.

5.Press the On/Off button to switch off your radio.

If you need any further advice, please call our Technical Helpline on :-

1 2

3

3

4

5

020 8758 0338 (Mon-Fri)	12

Image 13

Contents CR9935 Important Information please read before use Automatic Plug and Play setup Controls Top Controls Left side Right side 1718 Headphone socket Volume controlDisplay Display backlight Mains operationNight light Setting the clock automatically Setting the day of week manually Setting the clock manuallyDisplaying the alarm time Setting the alarm timesWake to buzzer Wake To radio Sleep timerSnooze control Operating your radio search tuning Weekend alarm cancelOperating your radio manual tuning Pre-setting stations Last station memory Recalling a preset stationProgramme Service PS name Clock Time CT automatic adjustmentProgramme Identification PI Programme Type PTYDisplay Modes Operating your radio using RDS Radio data systemProgramme type display PTY Traffic Announcements TA Programme Type search PTYPage Headphones Demonstration modeGeneral Back-up battery not necessary for the unit to functionMains supply FusePower Requirements Specifications Circuit FeaturesRoberts Radio Technical Services Department