Roberts Radio CR9935 manual Automatic Plug and Play setup

Page 3

Automatic Plug and Play setup

When your Clock Radio is first connected to the mains supply or after a power failure (when backup battery is not installed), the Auto setup will proceed as follows:-

• Automatically search all wavebands and store stations in presets.

• Automatically set the time and day of week.

1.Connect to mains (see page 6). Your radio will show "SEARCHING FM PLEASE WAIT' followed by a Demonstration of the RDS features available.

2.Your radio is ready for use when the Auto Time indicator stops flashing.

3. The auto time indicator will flash in the display whilst time setting is carried out.

4. If the first station detected by the automatic setup does not carry Clock Time information your radio will automatically change to another station after 1-2 minutes. This process will repeat until the clock is set.

5. Press the Power button to switch on your radio and press one of the

 

Preset buttons to select a station. Adjust the volume using the

 

Volume control. To switch off your radio press the Power button.

5

Note:- Auto setup can take up to 5 minutes to complete and is

dependent on the signal strength and number of stations in your area.

To interrupt the Auto setup press and release the Memo button.

Should Auto setup fail, setting the clock and pre-setting stations can be carried out manually as described in the following sections.

If you need any further advice, please call our Technical Helpline on :-

5

020 8758 0338 (Mon-Fri)

2

 

Image 3
Contents CR9935 Important Information please read before use Automatic Plug and Play setup Controls Top Controls Left side Right side 1718 Headphone socket Volume controlDisplay Mains operation Display backlightNight light Setting the clock automatically Setting the day of week manually Setting the clock manuallySetting the alarm times Displaying the alarm timeWake to buzzer Sleep timer Wake To radioSnooze control Operating your radio search tuning Weekend alarm cancelOperating your radio manual tuning Pre-setting stations Last station memory Recalling a preset stationProgramme Type PTY Clock Time CT automatic adjustmentProgramme Service PS name Programme Identification PIDisplay Modes Operating your radio using RDS Radio data systemProgramme type display PTY Traffic Announcements TA Programme Type search PTYPage Headphones Demonstration modeFuse Back-up battery not necessary for the unit to functionGeneral Mains supplyPower Requirements Specifications Circuit FeaturesRoberts Radio Technical Services Department