SKU 1102 For technical questions, please call 1-800-444-3353. Page 5

Specications

Max. Air Pressure 90 PSI
Air Inlet Schrader (Bicycle) Valve
Capacity 16 uid ounces
Spray Buttons (4)
Coarse Spray (Green)
Medium Spray (Black)
Fine Spray (Blue)
Jet (No color; equipped
with opening for jet spray
extension)
INITIAL TOOL SET UP/ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.

Unpacking

When unpacking, make sure that
the item is intact and undamaged. If any
parts are missing or broken, please call
Harbor Freight Tools at the number shown
throughout the manual as soon as pos-
sible.
• This air tool may be shipped with a
protective plug covering the air inlet.
Remove this plug before set up.

Air Supply

TO PREVENT
EXPLOSION:
Use only clean, dry, regulated,
compressed air to power this
tool. Do not use oxygen,
carbon dioxide, combustible
gases, or any other bottled
gas as a power source for this
tool.
1. Incorporate an in-line shut-off valve,
regulator with pressure gauge, and
lter for best service, as shown in the
diagram above. An in-line shutoff
valve is an important safety device
because it controls the air supply
in the event of an air hose rupture
or other emergencies.
2. Attach a tire chuck to one end of the
air supply hose and the other end
of the hose to the air supply (neither
one is supplied.)
Note: Air ow, and therefore tool perfor-
mance, can be hindered by under-
sized air supply components.