Air source
a.Never connect to an air source that is capable of exceeding 90 PSI. Over pressurizing the tool may
cause bursting, abnormal operation, breakage of the tool or serious injury to persons. Use only clean, dry, regulated compressed air at the rated pressure or within the rated pressure range as marked on the tool. Always verify prior to using the tool that the air source has been adjusted to the rated air pressure or within the rated
b.Never use oxygen, carbon dioxide, combustible gases or any bottled gas as an air source for the tool. Such gases are capable of explosion and serious injury to persons.
SAVE THESE
INSTRUCTIONS.
Specific Safety Instructions
1.The warnings and precautions dis- cussed in this manual cannot cover all possible conditions and situations that may occur. It must be under- stood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
2.Do not use with bottled gases.
3.Always keep Sealing Gasket (3) in place.
4.Check all local laws regarding use.
5.Do not puncture or incinerate Spray Can.
6.Do not use with corrosive products.
7.A tire chuck (not included) must be attached to the air supply hose in order to pressurize Spray Can.
8.Do not expose to heat or store at temperature above 120° F.
9.Obey the manual for the hand pump and the compressor used to power this tool.
10.Flush the system with pressurized clean water after use with liquids other than water.
11.Do not overfill the Spray Can. It holds 16 fluid ounces (max. filled liquid should not exceed 8 fluid ounc- es.)
12.Read warnings of fluids and applica- tions used with Spray Can. Adhere to all safety warnings concerning han- dling of applications.
13.DO NOT spray up wind.
14.Before storing, discharge contents, flush with clean water, and wash and dry exterior. Then store in a safe place out of reach of children.
SAVE THESE
INSTRUCTIONS.
SKU 1102 | For technical questions, please call | Page 4 |
