3.Close the
4.Turn on the air compressor according to the manufacturer’s directions and allow it to build up pressure until it cycles off.
5.Adjust the air compressor’s output regulator so that the air output is enough to properly charge the tool, but the output will not exceed the tool’s maximum air pressure require- ment at any time. Adjust the pres- sure gradually, while checking the air output gauge to set the right pressure range.
6.Inspect the air connections for leaks. Repair any leaks found.
Note: Residual air pressure should not be present after the tool is disconnected from the air supply. However, it is a good safety measure to attempt to discharge the tool in a safe fashion after disconnecting to ensure that the tool is disconnected and unpowered.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts. If any problems
are found, do not use tool until repaired or replaced.
Tool Set Up
TO PREVENT SERIOUS INJURY:
Do not adjust or tamper with any control or component in a way not specifically explained within this manual. Improper adjustment can result in tool failure or other serious hazards.
General Operating Instructions
1.Twist off the Head Unit (1) from the Tank (4) and inspect the Sealing Gas- ket (3). Replace if damaged.
2.If used with liquids, fill ONLY halfway with the liquid to be sprayed (max. 8 fluid ounces.)
3.Replace the Head Unit and twist shut.
4.Unscrew and remove Valve Cap (10), place the other end of Cap into valve stem and check that valve core (not shown) is tight.
5.Attach Air Chuck to Valve Stem (2).
6.Pressurize Spray Can to 90 PSI max. WARNING! Be careful of discharge during fitting.
7.Fit selected Spray Button onto top of Head Unit:
a.) Coarse Spray - Green Button
(6). Use on heavy viscous liquids such as oil and wax
b.) Medium Spray - Black Button
(7). Use on medium viscous liquids such as paints, window cleaner.
SKU 1102 | For technical questions, please call | Page 6 |
