SOFTWARE SETUP
The default settings of TE100-S55 (shown in Appendix A, page 45) should be sufficient in the majority of installations. If a different setting is required for your specific environment, please refer to Chapter 3, page 21 for “Out-of-Band Management” or Chapter 4, page 35 for “SNMP Management”.
For simple management, you can perform the Out-of-Band Management and access the TE100-S55 through its RS-232 port. For elaborate SNMP management, you can run the XPressView program from any network station.
CHECKING STATUS LEDS
When the power is first turned on, TE100-S55 performs a Power- On Self Test (POST). Please observe the status LEDs for verification of proper installation (for more detail, refer to Chapter 5, page 41). These status LEDs also provide information about the system unit and its connected Ethernet or Fast Ethernet LAN segments, during normal operation.
Figure Chapter 2 -6, TE100-S55 status LEDs
20
