Cables to Go TE100-S55 manual Control Settings, System display, User selection

Upon a successful execution of terminal emulation, your computer will establish communication with the TE100-S55 and allow you to view or modify the following settings.

Control Settings	System display	User selection
Switch	Switch Version No.	V1.10 (Fixed)
Configuration	Switch IP Address	168.8.xx.xx
	Switch Subnet Mask	255.255.0.0
	Default Gateway	0.0.0.0
	Switch MAC Addr.	Factory preset (Fixed)
	Save change	F2 key
	Exit	F4 key
Port Configuration	Port/x State	Enable (or Disable)
	Port/x Physical	Auto (or 100/Half, 100/Full,
		10/Half, 10/Full)
	Port/x State	Block, Learning, Listening,
		Forwarding, Disable (Fixed)
	Port/x Priority	0 (Hi) - 255 (Low)
Spanning Tree	Enable / Disable	Enable (or Disable)
Configuration	Bridge (switch) Priority	32768
	Root Cost	(Reflected STA result)
	Hello Time	10 sec. (range: 1 - 10 sec.)
	Forward Delay Time	30 sec. (range: 4 - 30 sec.)
	Max Age Time	40 sec. (range: 6 - 40 sec.)
	Root Bridge	(MAC addr. of Root Bridge)
	Root Port	(Reflected STA result)
Down-load new	Y / N	Space Key (toggle)
system firmware	Exit	F4 key
Load factory default	Y / N	Space Key (toggle)
parameters	Exit	F4 key
Filtering Data Base	Port Number	1 ~ 5
	Port State	Disable (or Forwarding,
		Blocking)
	MAC address	Up to 16 MAC addresses

Table Chapter 3 -2, TE100-S55 Settings for Out-of-Band management

24