USER-SELECTIVE PARAMETERS
The
From the Switch Configuration menu, you can change the IP Address of
From the Port Configuration menu, you can Enable/Disable each port connection , and prioritize them (ranges from 0 to 255). The priority level, in conjunction with the preset port ID, is used under the Spanning Tree Algorithm to determine the “Root Port”. The Port State parameter corresponds to the Enable/Disable port settings and the dynamic changes in routing paths of the surrounding network. The Port State may show message Blocking, Learning, Listening, Forwarding or Disable, at any given time.
The Port Physical setting defaults to AUTO, but you can change it to 100Mb half duplex, 100Mb full duplex, 10Mb half duplex, or 10Mb full duplex mode. Although optional, the AUTO setting is recommended since it employs the NWAY
From the Spanning Tree Configuration menu, you can Enable/Disable the STA function, change the switch priority and various timers. The STA functions and parameters are discussed in full detail on page 27.
25