Operating the radio
Your clock radio is equipped with three tuning methods:- Scan tuning, |
|
|
Manual tuning and Memory preset tuning. When | 1 | 2 |
radio will display the waveband and frequency in use. |
Scan tuning
1. Press the On/Off button to switch on the radio.
2. Select the required waveband by repeatedly pressing the Band button. On the FM waveband fully extend the Wire aerial located on the rear of your clock radio - for MW and LW rotate your clock radio for best reception.
3. Press and hold down either the up or down button buttons for more the 0.5 sec and then release to commence scan tuning.
4. Your radio will scan the selected waveband and stop automatically when it finds a station of sufficient strength. The station frequency will appear in the display.
5. To recommence scan tuning, again press and hold down either the up or down button buttons for more the 0.5 sec and then release to recommence scan tuning.
6. When the waveband end is reached the radio will beep and continue tuning from the opposite waveband end.
7. Adjust the Volume control to the required setting.
33
8. To switch off your radio press the On/Off button.
7
8
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 | 10 |
|