Panasonic SC-PM86D Placement of speakers, Preparing the remote control, Demo function, Use

Page 5

Placement of speakers

Speakers are designed identically so that no left or right channel orientation is necessary.

Caution

Use the speakers only with the recommended system. Failure to do so can damage the amplifier and speakers, and can cause fire. Consult a qualified service person if damage occurs or if a sudden change in performance is apparent.

Do not attach these speakers to walls or ceillings.

Use only the supplied speakers

Using other speakers can damage the unit, and sound quality will be negatively affected.

Place speakers on flat secure bases. Take proper precautions to prevent the speakers from falling if you cannot set them up on an even surface.

Preparing the remote control

If irregular coloring occurs on your television.

The front speakers are designed to be used close to a television, but the picture may be affected with some televisions and setup combinations.

If this occurs, turn the television off for about 30 minutes.

The television’s demagnetizing function should correct the problem. If it persists, move the speakers further away from the television.

Note:

Keep your speakers at least 10mm away from the system for proper ventilation.

You can damage your speakers and shorten their useful life if you play sound at high levels over extended periods.

Reduce the volume in the following cases to avoid damage:

When playing distorted sound.

When the speakers are reverberating due to a record player, a microphone (except For the United Kingdom, Continental Europe, Australia and N.Z. ), noise from FM broadcasts, or continuous signals from an oscillator, test disc, or electronic instrument.

When adjusting the sound quality.

When turning the unit on or off.

To avoid damage to the speakers, do not touch the speaker cones if you have taken the nets off.

ENGLISH

GETTING STARTED

DANSK

2

1Insert so the poles

(+ and –) match those in the remote control.

R6/LR6, AA

CAUTION

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions.

Do not use rechargeable type batteries.

Do not heat or expose to fl ame.

Do not leave the battery(ies) in an automobile exposed to direct sunlight for a long period of time with doors and windows closed.

Do not:

mix old and new batteries.

use different types of batteries at the same time.

take apart or short circuit the batteries.

attempt to recharge alkaline or manganese batteries.

use batteries if the covering has been peeled off.

Mishandling of batteries can cause electrolyte leakage which can severely damage the remote control.

Remove the batteries if the remote control is not going to be used for a long period of time. Store in a cool, dark place.

Use

Aim at the remote control signal sensor (\ page 10), avoiding obstacles, at a maximum range of 7 m directly in front of the unit.

FRANÇAIS

LANG - 4

DEMO function

7, –DEMO

When the unit is fi rst plugged in, a demonstration of its functions may be shown on the display.

If the demo setting is off, you can show a demonstration by selecting “DEMO ON”.

Press and hold [7 , –DEMO].

The display changes each time the button is held down.

DEMO OFF DEMO ON

While in standby mode, select “DEMO OFF” to reduce power consumption.

LANG - 5

RQTV0265

5

Image 5
Contents DVD Stereo System SC-PM86D SystemMain unit SA-PM86DFrançais Dansk English For United Kingdom, EB area code model only Safety precautionsPreparing the remote control Placement of speakersDemo function UseAM loop antenna FM indoor antenna Simple setupTelevision with an Hdmi terminal Television with Scart terminalTelevision with Component Video Terminals Television with a Video in terminalDetails of settings Performing Quick SetupDisc handling precautions To clean discsCommercial discs Disc informationDiscs that cannot be played Video systemsOverview of controls To cancel To cancel the timerSet the clock Show the setup menu To confirm the remaining timeStop Discs Basic playPause Slow-motion play during pauseDiscs Advanced play Using the Start menuProgram and Random play Discs Advanced playRepeat play Program play up to 30 itemsPlaying data discs Playing RAM and DVD-R/-RW DVD-VR discs Discs Playing data discs using navigation menusPlaying items from the menu Playback Menu Playing from the selected item Playing the programsFunctions menu Discs Using on-screen menusTrack Search Audio Play SpeedNormal Auto NormalVideo FilmDiscs Using on-screen menus Confirming Hdmi information Discs Changing the player settingsConnected State Audio Stream PCM MAX Channel Video FormatMain menu Discs Changing the player settingsDisc tab Video tabOthers tab Display tabHdmi tab Tips for making data discs About DivX VOD contentManual tuning Using the FM/AM radioMemory preset Selecting the preset channelsVocal cancel function Microphone volume adjustment by main unit onlyAdding an echo effect Enjoying simple karaoke with other sourcesUsing the timers Using sound effectsConnecting and playing a USB mass storage device Using other equipmentAvoid interfering with other Panasonic equipment Before connectionConnecting the Universal Dock for iPod 3 Connecting to a portable audio equipmentConnecting to other external unit Music PUsing other equipment Automatic setup Troubleshooting guide Hdmi or Progressive video Sound abnormal or improperPicture abnormal or unviewable Using the USB device Troubleshooting guideUnit displays Television displaysRelease /I Language code listMemory reset Initialization MPEG4 GlossaryNorsk SpecificationsSpecifications Maintenance