Playing a CD+G Disc, Programming a CD or CD+G Disc

Playing a CD+G Disc

Step 1: Press the Power Button to turn the unit on.

Step 2: Load the CD+G disc into the unit’s CD drive.

Step 3: Adjust the Source Dial to CDG.

Step 4: Press the Play/Pause Button to play the loaded disc.

Step 5: Plug in the included microphone to the Mic 1 Connection. Adjust the On/Off Switch on the microphone to the On position.

•If feedback noise is present, move the microphone away from the unit and/or reduce the microphone’s volume.

Step 6: Adjust the Volume Dial to adjust the volume of audio output from the speakers. Adjust the Microphone Volume Dial to set the volume of a connected microphone.

Step 7: Turn the AVC Select Dial to Vocal.

Step 8: Use the AVC Dial to adjust the balance between the music and vocals.

Step 9: Press the Play/Pause Button to play or pause the loaded CD+G.

Programming a CD or CD+G Disc

Step 1: Press the Power Button to turn the unit on.

Step 2: Load the CD or CD+G into the unit’s CD drive.

Step 3: Adjust the Source Dial to CDG.

Step 4: Press the Program Button to begin programming the disc.

• The Program Indicator Light will illuminate red.

Step 5: Select a CD or CD+G track using the Skip/Search Buttons.

Step 6: Once the desired track is selected, press the Program Button.

Step 7: Repeat Step 5-6until all of the desired tracks are programmed. (19 max)

Step 8: Press the Play/Pause Button to beging playing the programmed tracks.

IJ328-IB.indd 9

7/10/2008 2:21:42 PM