Panasonic RX-ES20 operating instructions Before use, Fuse Ampere

Page 3

Caution for AC Mains Lead

(For United Kingdom)

(“EB” area code model only)

For your safety, please read the following text careful- ly.

This appliance is supplied with a moulded three pin mains plug for your safety and convenience.

A 5-ampere fuse is fitted in this plug.

Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 5-ampere and that it is approved by ASTA or BSI to BS1362.

Check for the ASTA mark m or the BSI mark o on the body of the fuse.

If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced.

If you lose the fuse cover the plug must not be used until a replacement cover is obtained.

A replacement fuse cover can be purchased from your local dealer.

CAUTION!

IF THE FITTED MOULDED PLUG IS UNSUIT- ABLE FOR THE SOCKET OUTLET IN YOUR HOME THEN THE FUSE SHOULD BE RE- MOVED AND THE PLUG CUT OFF AND DIS- POSED OF SAFELY.

THERE IS A DANGER OF SEVERE ELECTRI- CAL SHOCK IF THE CUT OFF PLUG IS IN- SERTED INTO ANY 13-AMPERE SOCKET.

If a new plug is to be fitted please observe the wiring code as stated below.

If in any doubt please consult a qualified electrician.

IMPORTANT

The wires in this mains lead are coloured in accor- dance with the following code:

Blue: Neutral, Brown: Live.

As these colours may not correspond with the co- loured markings identifying the terminals in your plug, proceed as follows:

The wire which is coloured Blue must be connected to the terminal which is marked with the letter N or col- oured Black or Blue.

The wire which is coloured Brown must be connected to the terminal which is marked with the letter L or co- loured Brown or Red.

WARNING: DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL WHICH IS MARKED WITH THE LETTER E, BY THE EARTH SYMBOL n OR

COLOURED GREEN OR GREEN/YELLOW.

THIS PLUG IS NOT WATERPROOF—KEEP DRY.

Before use

Remove the connector cover.

How to replace the fuse

The location of the fuse differ according to the type of AC mains plug (figures A and B). Confirm the AC mains plug fitted and follow the instructions below.

Illustrations may differ from actual AC mains plug.

1. Open the fuse cover with a screwdriver.

Figure A

Figure B

Fuse cover

2.Replace the fuse and close or attach the fuse cov- er.

Figure A

Fuse

(5 ampere)

Figure B

Fuse

(5 ampere)

Before use

3

RQT5189

Image 3
Contents RX-ES20 Dear Customer Precautions Table of ContentsSupplied Accessories Fuse Ampere Before useUse of Batteries Power SourcesOperating the unit on AC power Using batteries not includedCassette deck controls Location of ControlsBasic controls Tuner/CD controlsRemote Control ButtonsUse Setting the Clock Using Headphones not includedDisplaying the clock If noise is excessive in FM Normal tuningUsing auto scan RadioRadio Preset tuningPresetting radio stations Using preset scanCD selection CDsRepeat play Direct access playCDs Other modes of playProgram play ListeningTo display the tape counter while recording CassettesTips on Recording Cassette tape careErasure prevention Recording CDsTips on Recording Normal recordingRecording CDs If a track is interrupted at the end of the side facing upPress 0 DECK, flip the cassette, and insert it Press / . K Recording the Radio RecordingREC Sound Quality and Sound Field Press Preset EQ to select a settingSound Quality Sound with the Sound VirtualizerTimer Play and Record TimerFor a cleaner crisper sound Sleep TimerTimer Fader MaintenanceTechnical Specifications Troubleshooting