Sirius Satellite Radio SB4000 manual Boombox Controls

Boombox Controls

The OrbiterTM SB4000 Boombox provides two control buttons, a Power On/Off -Volume control, and a push- button to toggle between Satellite Radio or an auxiliary audio input signal. A power-on LED is also located on

the front panel. 6

1 2 3 4 5

1.PHONES: Accepts a stereo headphone jack to provide private listening capability for the Boombox.

2.MODE Selector Push-button: Push button toggles between Satellite Radio and an external audio input signal (MP3, CD, etc.) present at the AUX input jacks.

4

3.AUX Jack: Accepts an audio input signal from an external audio device. When using theAUX audio input, turn the Orbiter SR4000 Off to preserve battery power. Adjust the volume level of the external audio device to obtain an audio output from the SB4000. The volume control on the external audio device should be set to a mid-range level.

4.Power On/Low Battery LED: The LED lights green when the Power On/Off Switch- VOL control is rotated clockwise (CW) to the ON Position. In addition, the LED will light red to alert the user that the batteries are nearly discharged. This condition may cause degraded performance of the SB4000.

5.Power ON/OFF Switch-VOL Control: Applies power to the Boombox when rotated clockwise (CW) from the Off position. When in the ON position, increase or decrease the volume of the audio output signal from the SB4000. To increase the volume level rotate the control CW. To decrease the volume level, rotate the control counterclockwise (CCW).

6.Release Button: Press this button to release and remove the Orbiter SR4000 from the SB4000 Boombox cradle.

SB4000 Boombox User Guide

1. Battery Installation: Your Boombox can operate		2. Cabling Interconnections: You can begin to enjoy
independently of AC power by installing 8 “D”		Sirius Satellite Radio as soon as the Orbiter SR4000
batteries as follows:		Receiver and SB4000 Boombox installation are
NOTE: The batteries are bypassed automatically		complete. Set up your Orbiter SB4000 by following the
whenever the suppliedACAdapter is plugged into		interconnect diagram.
the DC 12V jack on the back panel.		3. Installing the SR4000 Receiver in the SB4000
a. Turn the Boombox upside down to access the		Boombox: Place the SR4000 Receiver in the cradle
battery compartment.		so that the guides are lined up with the SB4000
b. Push the battery cover latches forward and flip up		Boombox cradle. Then push the SR4000 down to
the battery compartment cover to the open position		engage the connectors. The SR4000 will snap into
c. Insert eight 8 “D” batteries observing battery polarity		place. Apply power to the SB4000 by rotating the VOL
as shown, then close the cover.		control clockwise from the OFF position; the LED
Battery Compartment	Battery Compartment	indicator lights green. If the SR4000 does not turn on at
		the same time, press the RED Power ON/OFF button
Cover	Cover Latches
		in the upper left corner of the SR4000 front panel.
		4. Removing the SR4000 Receiver From the SB4000
		Boombox: Press and hold the EJECT button on top of
		the Boombox; the SR4000 Receiver will partially eject
Bottom of SB4000 Boombox		forward. Using your thumb and forefinger, grasp the
		SR4000 on the
Positive (+)	Negative (-)
		sides and pull up
		to disengage.
Negative (-)	Positive (+)
Battery Compartment Cover Removed		5
SB4000 Boombox User Guide