Altec Lansing IMT520 manual Maintaining Your Speaker System, Select AUX mode

Listening to a Non-docking iPod or Other Portable Audio Device

If you have a non-iPod MP3 player or other non-docking portable audio device, you can enjoy it through your Altec Lansing inMotion Kick speaker system as well. Just connect it via the AUX jack. Here’s how:

1Locate a 3.5mm stereo cable (not included).

2Plug one end of the stereo cable into your device.

Your device should have either a headphone or LINE OUT jack for you to plug into.

3Plug the other end of the stereo cable into your speaker system’s AUX jack.

The AUX jack is located on the back of the unit.

4Select “AUX” mode.

Press the “SOURCE” button on your speaker system or the full-featured remote until the “AUX” LED lights up.

5Turn on your device and start it playing.

6Adjust the volume.

Use the “+” and “–” buttons on the speaker system or full-featured remote to adjust the volume.

NOTE You may need to adjust the device volume also. Your device’s volume should be set to approximately ¾ volume.

7 When you are finished listening to your portable audio device,

please remember to turn both it and your speaker system off to conserve electricity.

Maintaining Your Speaker System

Place your speaker system on a level surface away from sources of direct sunlight or excessive heat.

Protect your furniture with a cloth or other protective material when placing your speaker system on a natural wood or lacquered finish.

Clean your speaker system with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such as benzene, thinner or similar materials, can damage the surface of the unit.

EN

13