Nordyne E3 user service Furnace Inspection Report

Furnace Inspection Report

	Please Write In Appropriate
		Response
Electrical Wiring (If single circuit, write “N/A” in circuit B)	Circuit A	Circuit B
Breaker Size?
Furnace Wire Size?
Thermostat Wire Size?
	Please Circle Appropriate
		Response
Electrical
Is the furnace grounded properly?	Yes	No	N/A
Is wiring routed safely with approved connectors?	Yes	No	N/A
Closet Installation
Is front clearance a minimum of 6 inches?	Yes	No	N/A
Is return air opening a minimum of 235 sq. inches?	Yes	No	N/A
Is front clearance less than 6 inches (minimum of 1 inch)?	Yes	No	N/A
Is return air opening a minimum of 250 sq. inches?	Yes	No	N/A
Does the furnace have the 5-ton AC coil installed?	Yes	No	N/A
Is the return air opening a minimum of 390 sq inches?	Yes	No	N/A
Plenum (Base) Connector
Is mounting plate secured properly?	Yes	No	N/A
Is furnace locked and secured in front?	Yes	No	N/A
Is plenum free of debris?	Yes	No	N/A
Has plenum opening been reduced in size to accommodate	Yes	No	N/A
offset?
Has plenum spacer been removed if duct size is large enough?	Yes	No	N/A
Testing
Is someone in the plant trained to perform duct tests?	Yes	No	N/A
VentilAire III __ IV__
Is VentilAire duct connected properly to furnace?	Yes	No	N/A
Is depressurization vent (if required) installed properly?	Yes	No	N/A
Is roof assembly installed properly?	Yes	No	N/A
Is roof assembly a minimum of 3 inches from any other vents?	Yes	No	N/A
General
Is filter in place?	Yes	No	N/A
Is owner’s packet included?	Yes	No	N/A
Checked storage area for damage to product and proper	Yes	No	N/A
storage?
Is installation in accordance with installation instructions?	Yes	No	N/A

Comments:

30