Appendix B: Painting the Zx1™ Speakers
Painting Process
The Zx1™ is made of
·Remove the grille and mask the baffle.
·Clean the cabinet and grille by rubbing the speaker with a lightly dampened cloth. Do not, however, use abrasives such as sandpaper or steel wool. Never use gasoline, kerosene, acetone, MEK, paint thinner, harsh detergents, or other chemicals, as these agents may cause permanent damage to the enclosure.
·After cleaning, apply latex or enamel paint. Spraying is recommended
Painting the Grille
Painting the grille requires spray painting. If the grille is rolled or brush painted, the mesh may become clogged with paint and poor sound quality may result.
Appendix C: Technical Specifications
Freq. Response1 | 60 Hz - 20 kHz |
Freq. Range1 | 48 Hz - 20 kHz |
Rec. Hipass Frequency: | 40 Hz |
|
|
Axial Sensitivity1 (90°): | 94 dB (1W/1m) |
(100°): | 92 dB (1W/1m) |
Max Calculated SPL (90°): | 123 dB |
(100°): | 121 dB |
Horizontal Coverage: | 90° or 100° |
|
|
Vertical Coverage: | 50° or 100° |
|
|
Rated System Power: | 200W Cont.2, 400W Prog., 800W Peak |
LF Transducer: | EV8L, 8 in (203mm) Driver |
|
|
HF Transducer: | DH2005, 1 in. (25.4mm) Exit |
| Compression Driver |
Crossover Frequency: | 1.7 kHz |
Nominal Impedance: | 8 Ohms |
|
|
Minimum Impedance: | 6 Ohms |
|
|
"T" Version Wattage Taps: | 70V - 6, 12.5, 25, 50, 100, 8 Ohm bypass |
| 100V - 12.5, 25, 50, 100, 8 Ohm bypass |
|
|
Connectors: | |
|
|
Enclosure Material: | High Impact Polymer |
|
|
Suspension: | Integrated QuickSAMTM |
| |
Grille: | Polyester Powder Coated, 18GA |
| Galvanized Steel |
Dim (H x W x D): | 451mm x 282mm x 263mm |
| (17.75" x 11.12" x 10.35") |
Net Weight: | 8.4 kg (18.5 lbs) without Transformer |
| 10.4 kg (23.0 lbs) with Transformer |
Shipping Weight: | 10.2 kg (22.5 lbs) without Transformer |
| 12.3 kg (27.0 lbs) with Transformer |
1Half Space Measurement.
2IEC Pink Noise, 6 dB Crest Factor.
11 |