Electro-Voice Zx1i-90 Select Voltage Tap Zx1i-100T model only, Voltage Tap Selector Detail

Page 6

Step 2: Select Voltage Tap (Zx1i-100T model only)

Before attaching the speaker to the bracket, select the proper voltage tap setting for your installation. The voltage selector switch is located at the rear of the speaker below the input terminal panel. The power taps are 100, 50, 25W and 12.5W at both 70.7V and 100V, with a 6W tap for 70.7V only. There is also an 8 ohm bypass setting. The taps are selected by a rotary switch on the back panel. A guide on the back of each speaker shows which switch positions to use for the power settings at 70V and 100V. Figure 7 below illustrates the settings.

Voltage Tap

Selector

Voltage Tap

Detail

Figure 7: Voltage Tap Selector (Zx1i-100T Model Only)

6

Electro-Voice®Zx1i Owner’s Manual

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Zx1i Series Loudspeaker Table of Contents Zx1i-100 Model SummaryZx1i-90 Zx1i-100TProduct Feature Identification QuickSAM Strong-Arm-Mount SystemStep-by-Step Installation and Wiring Mount the SAM Bracket to Mounting SurfaceSelect Voltage Tap Zx1i-100T model only Voltage Tap Selector DetailSelect the horn dispersion orientation- If necessary EnclosureAttaching Speaker to QuickSAMTM Assembly Attach the Speaker to the QuickSAM BracketMaintenance Wire the SpeakerConnector Secure the Seismic Tab Connection PointDetaching the speaker from the QuickSAM Bracket Press HerePainting Process Painting the GrilleAll Locations Fax Telex Communications, Inc
Top Page Image Contents