Control Unit

NAMES AND FUNCTIONS

(1)OP/CL

Press it to open and close the disc holder. The main unit also includes OPEN/CLOSE buttons. The disc holder cannot be opened during playback, so stop playback before pressing the button.

(2)TIME (Time Button)

Press this button to switch the time display among the elapsed time and remaining time and total remaining time of the disc.

(3)LCD

(4)RELAY

Use a std. Mini plug (stereo) to plug in Side1 to Side 2. Set both sides of the CD player to single node on the control. When Disc 1 ends the CD player will automatically change to Disc 2 and when Disc 2 ends it will return to Disc 1,etc.

(5)PITCH - BUTTON

The CD slows down while this button is pressed. Release the button to return to the original BPM.

(6)PITCH + BUTTON

The CD speeds up while this button is pressed. Release the button to return to the original BPM.

(7)PITCH LOCK

Use these button to enable or disable BPM adjustment with the pitch sliders. BPM adjustment with the pitch sliders is enabled when the PITCH LED lights.

(8)PITCH SLIDER

Use the slider to adjust the CD pitch. Slide up to decrease the pitch, down to increase the pitch.

(9)PLAY/PAUSE

Use the button to start playback. Press once to start playback, once again to set the pause mode, and once

more to resume playback.

(10)SGL/CTN (Single/Continuous Button)

Press it to switch between the single and continuous play modes. The SINGLE mode is indicated by the SINGLE indicator on the LCD

(11)CUE (Cue Button)

Press the CUE button during playback to return to the position at which playback started.

(12)+10/-10

Use the button to skip ahead 10 tracks. Use the button to rewinds 10 tracks.

(13)

Use these button to go back to the beginning of the current track or select a previous track for playing.

(14),(15)

Press these buttons to perform scan function during pause mode or during play mode.

(16)

Use these button to skip to the next CD track.

(17)PITCH RANGE

Choose from pitch percentages of 4%,8% and 16%.

(18)CONTROL CONNECTOR

Connect this connector to the REMOTE connector on the main unit using the included control cord.

(19)FADER START SOCKET

Via the Control socket, the respective CD-player can be remotely controlled. If you are using a mixer with fader start-function connect the player with the Control Out- socket. Please note that these sockets must never be connected with any voltage.

LCD

(20)~(23)Track, Minute, Second and Frame Displays

These displays indicate information for the CD’s current position and time.

(24)BAR Indicator

These ten indicators provide a visual display of the approximate position of the pickup within the current track.

(25)REMAIN Indicator

It indicates that the time shown on the display is the remaining time of playing track

TOTAL REMAIN time of playing back

(27)CONTINU Indicator

When the indicator lights, the function will cause the unit to play continuously.

(28) PITCH DISPLAY

It shows the BPM change range, the BPM changes within a range of +/-16%.

(26)TOTAL Indicator

It indicates that the time shown on the display is the