Panasonic SCPT1050, SCPT950 Using the FM/AM radio, If noise is excessive, Presetting the channel

Page 29

Using the FM/AM radio

TUNER/BAND

Numbered buttons

, ,

∫ If noise is excessive

When “FM” is selected

Press and hold [—FM MODE] on

D.MIX MONO SLP STCT

DDTS

PL

the main unit to display

SRDE. PRG

“MONO”.

PGMRNDRDS

EQ W1 W2

WS

Press and hold [—FM MODE] again to cancel the mode.

≥The mode is also canceled when you change the frequency.

When “AM” is selected

Press [FUNCTIONS] on the remote control.

Each time you press the button: BP 2()BP 1

ENTER

FUNCTIONS

 

Manual tuning

 

 

 

1

Press [TUNER/BAND]§1 to select “FM” or “AM”.

SELECTOR

-TUNE MODE/-FM MODE

2 Press [6, 5]§2 to select the frequency.

≥When performing this step on the main unit, first press

[-TUNE MODE] to select “MANUAL”, and then press [X TUNING W] to select the frequency.

TUNING MEMORY

Radio operations are described mainly with the remote control.

You can alternatively use the corresponding button on the main unit.

§1 [SELECTOR]

§2 [X TUNING W]

§3 [MEMORY]

Presetting stations automatically

Up to 30 stations can be set in each band, FM and AM.

1

Press [TUNER/BAND]§1 to select “FM” or “AM”.

2

Press and hold [ENTER]§3.

 

Release the button when “FM AUTO” or “AM AUTO” is displayed.

≥To start automatic tuning, press and hold [6, 5]§2 until the frequency starts scrolling. Tuning stops when a station is found.

∫ Presetting the channel

Up to 30 stations can be set in each band, FM and AM.

1While listening to the radio broadcast

Press [ENTER]§3.

2While the frequency and “PGM” are flashing on the display

Press the numbered buttons to select a channel.

≥To select a 2-digit number

DISC S.SRD TG KARA D.MIX MONO SLP

e.g. 12:

[S10] ➜ [1] ➜ [2]

Alternatively, press [X, W], and then press [ENTER]§3.

A station previously stored is overwritten when another station is stored in the same channel preset.

Using the FM/AM radio

 

The tuner tunes to the lowest frequency and starts to preset all the

 

 

 

FM frequency step

 

stations it can receive into the channels in ascending order.

\Main\unit\only]

 

≥“SET OK” is displayed when the stations are set, and the radio

 

The step is factory-set to 0.2-MHz, but you can change it to receive

 

tunes to the last preset station.

 

 

 

broadcasts allocated in 0.1-MHz steps.

 

≥“ERROR” is displayed when automatic presetting is unsuccessful.

 

1 Press [SELECTOR] to select “FM”.

 

Preset the channels manually (➜ right).

2 Press and hold [SELECTOR].

 

 

 

 

 

 

After a few seconds the display changes to show the current minimum

 

 

 

frequency. Continue to hold the button down. The minimum frequency

 

Selecting the preset channels

 

changes and the step is changed.

 

 

 

To return to the original step, repeat steps 1 and 2.

1

Press [TUNER/BAND]§1 to select “FM” or “AM”.

[Note]

 

 

 

2

Press the numbered buttons to select the channel.

After changing the setting, previously preset frequencies will be cleared.

Preset them again.

 

≥To select a 2-digit number

 

 

 

 

SB DISC S.SRD TG KARA D.MIX MONO SLP

 

 

 

e.g. 12: [S10] ➜ [1] ➜ [2]

 

 

 

DVD

 

 

 

Alternatively, press [X, W].

CD

 

 

 

ODE

 

 

≥To perform this step on the main

unit, first press [-TUNE MODE] to select “PRESET”, and then press [X TUNING W] to select the channel.

When a stereo FM broadcast is being

received, “ST” lights in the display.

SLP STCT

DDTS

PL

 

SRDE. PRG

 

 

PGMRNDRDS

 

 

EQ W1 W2

WS

RQTX0064

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Region number If you have any questions contactExample A.andCanada\U.S.A.\and\Canada Following Applies only in the U.S.A. and CanadaFollowing Applies only in the U.S.A Table of Contents Assembling the front speakers Speaker assembly optionPreventing the speakers from falling Assembling the front speakersPT950 PT953 PositioningPositioning Fitting speaker stands not included Speaker installation optionsAttaching to a wall Reattaching the front speaker cableCable connections FeaturesAudio and video connections Other connections for improved picture and audio qualityRadio antenna connections Speaker connectionsConnections CableDigital transmitter connection Using an FM/AM outdoor antenna optionalDo not insert or remove while the main unit is on Cable connections / Digital transmitter connectionIPod connection Before connecting AC power supply cord Set the voltageAC cord connections IPodPerforming Quick Setup Preparing the remote controlPT1050 Before using your wireless subwoofer BatteriesControl reference guide Control reference guideOperating the television Avoiding interference with other Panasonic equipmentMusic PORT/SETUP MIC Tune Mode / -FM Mode OPEN/CLOSEDisc Selector Disc ExchangeDiscs that can be played Disc handling precautionsDiscs that cannot be played Discs that can be playedTo clean discs MaintenanceClean this unit with a soft, dry cloth Tips for making data discsBasic play Using the main unitBasic play Press to select a disc directlyStop +, VolumeGroup Direct NavigatorDetails Convenient functionsBasics Program and Random play Press Play Mode while stoppedProgram play up to 32 items Random playUsing the submenu Playing data discs using navigation menusSelecting a track using CD text Playing data discsPlaying HighMATTM discs Playing data discs using navigation menusPlaying RAM and DVD-R/-RW DVD-VR discsMain menu Using on-screen menusUsing on-screen menus Play Menu Other SettingsPicture Menu Other Menu Audio MenuDisplay Menu Show the Setup menu Changing the player settingsSettings Disc menuHdmi menu Changing the player settingsVideo menu Player settings Changing the delay time of the speakersLanguage code list Others menuAuto input switching Using the EZ SyncTM Hdavi ControlTMPower off link One touch playIf noise is excessive Using the FM/AM radioPresetting the channel Optimizing the XM signal reception Using the XM Satellite RadioXM Satellite Radio ID Tips for optimizing receptionPresetting the XM channels Selecting the preset channelsUsing the XM Satellite Radio Selecting XM channels by direct entryUsing sound effects PT1050 Enhancing the bass To adjust speaker level during playSound H.BASS PT1050 Enhancing the surroundUsing the iPod Using the Music PortEnjoying audio from an external source Enjoying audio from the televisionGlossary / Product Service Product ServiceGlossary Product informationTroubleshooting guide Troubleshooting guidePower Unit displaysSound Disc operationPicture IPod with Universal Dock for iPodHdmi or progressive video Wireless equipmentRadio Television displaysXM Satellite Radio advisory messages User memoOthers SpecificationsPT950 PT1050 RMS Output Power Dolby Digital Mode PT950 PT953 Front\speakers\SB-HF950 Type SpecificationsPT950 PT953 Surround\speakers\SB-HS950 PT950 PT953 Center\speaker\SB-HC950Npcparts@us.panasonic.com Limited Warranty only for U.S.ALimited Warranty only for U.S.A Limited Warranty only for Canada Limited Warranty only for CanadaAccessories
Top Page Image Contents