SanDisk Clip-UM608-ENG user manual FCC Regulation

Page 26

7.Termination. We may terminate this Agreement and the license immediately and without notice if you breach it. Upon termination of this Agreement, you must delete or destroy all copies of the Software.

8.High Risk Activities. The Software is not fault-tolerant and is not designed or intended for use in hazardous environments requiring fail-safe performance, or any other application in which the failure of the Software could lead directly to death, personal injury, or severe physical or property damage (collectively, “High Risk Activities”). SANDISK AND ITS LICENSORS DISCLAIM ANY EXPRESS OR IMPLIED WARRANTY OF FITNESS FOR HIGH RISK ACTIVITIES AND SHALL NOT BE LIABLE FOR ANY LIABILITIES OR DAMAGES ARISING FROM SUCH USE.

9.General. This Agreement contains the entire understanding between the parties with respect to your use of the Software. If any part of this Agreement is found void and unenforceable, it will not affect the validity of the balance of this Agreement, which shall remain valid and enforceable according to its terms. This Agreement is governed by and construed under the laws of the State of California and controlling U.S. federal law without regard to conflicts of laws provisions thereof. The U.N. Convention on Contracts for the International Sale of Goods shall not apply to this Agreement. Any action or proceeding arising from or relating to this Agreement shall be adjudicated in the state or federal courts of Santa Clara County, California, and the parties hereby agree to the exclusive jurisdiction and venue of such courts. You will not remove or export from the United States or re-export from anywhere any part of the Software or any direct product thereof to any country in violation of U.S. Export Administration Regulations, or a successor thereto, except in compliance with and with all licenses and approvals required under applicable export laws and regulations including, without limitation, those of the U.S. Department of Commerce. Any waivers or amendments of this Agreement shall be effective only if made in writing and signed by an authorized representative of each party. You agree that the Licensors are third party beneficiaries of this Agreement to enforce your performance of the terms and conditions of this Agreement. The provisions of Sections 2, 3, 4, 5, 6, 7, 8 and 9 shall survive the termination or expiration of this Agreement.

FCC Regulation

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and then on, the user is encouraged to try to correct the interference by one or more of the following measures:

1.Increase the separation between the equipment and receiver.

2.Correct the equipment to a different outlet so that the equipment and receiver are on different branch circuits.

3.Consult the dealer or an experienced radio / TV technician for help.

Learn More, Service, and Warranty Information

24

 

Image 26
Contents Technical Support 866-SANDISK Clip-UM608-ENG Table of Contents Table of Contents Safety Tips & Cleaning Instructions Disposal InstructionsMinimum System Requirements FeaturesSansa Clip Overview Package Contents Sansa Clip at a GlancePlayback Screen Hold SwitchMain Menu Options Battery ChargingPower Button Basic UsageConnecting to your Computer Loading Contents Creating Playlist Transferring Playlist Right-click on Your Sansa Player then select Set Up Sync… Playing Contents MusicEQ Listening to FM Radio Programming FM PresetsFM Radio if applicable Recording Voice RecordingDeleting Music Files Equalizer SettingsPower Display BacklightReset All FM Settings if applicableVolume LanguageTips & Troubleshooting Why should I update the firmware?Getting Technical Support Learn More, Service, and Warranty InformationSanDisk Limited Warranty End User License Agreement Learn More, Service, and Warranty Information FCC Regulation