Wall Mounting, Tools required, Preliminary steps

Wall Mounting

The CRS-3 loudspeakers can be wall mounted vertically, for example, on either side of a plasma display. We recommend that the ribbon section is positioned at a height close to ear-level, therefore you can ﬁt the CRS-3 loudspeakers with the ribbon at the bottom if necessary.

The CRS-3C center loudspeaker can be ﬁtted horizontally, either above or below the plasma display.

The following brackets and screw hard- ware are supplied with each loudspeaker:

•Two small loudspeaker brackets

•One wall bracket

•Four screws and nylon washers to attach the loudspeaker brackets to the wall bracket

•Four 1/4-20 x 5/16” screws and washers to attach the loudspeaker brackets to the loudspeaker

•Three dry wall anchors and screws

Tools required:

•Phillips screwdriver

•Pencil or other marker

•Electric drill and 3/8" drill bit

•Safety glasses

•Sturdy ladder or step ladder

•Electronic stud ﬁnder if needed.

•You may need an assistant to help with the last steps.

Preliminary steps:

•Remove any speaker wires from the loudspeaker.

•Clear the area where you are going to work, so it will be safe. Remove any fragile objects, small children or pets, and cover anything that might be affected by dust from drill- ing.

•We recommend that you locate the bracket onto a wall stud if possible.

•If you have to mount the bracket onto a masonry wall, we recom- mend that you consult with your hardware supplier to buy suitable masonry hardware. If in doubt, please ask your Sunﬁre dealer to recommend a professional installer.

•Put on your safety glasses.

Procedure

•Secure the loudspeaker brackets to the rear panel of the loudspeaker using the four 1/4-20 x 5/16” screws and washers supplied.

The slotted holes in the side of the bracket should be down if you want the speaker to tilt up, or up if you want it to tilt down.

•On the rear of the loudspeaker, set the Boundary Compensation switch to the "Wall" position.

8		User's Manual