Mounting onto dry wall
•Place the wall bracket in position on the wall. Use your pencil to mark the three holes. Use the
Final Procedure
•Connect your speaker wires to the back of the loudspeakers, making sure of the correct polarity.
•Hold the loudspeaker in place, so the side holes in the loudspeaker brackets line up over the side holes of the bracket on the wall.
•With a 3/8" drill bit, drill three
•Press a dry wall anchor into each hole, and gently tap them in flush.
•After tapping the anchors flush, each screw needs to be fully tightened so the anchor collapses and holds itself to the wall. Then remove the screws and offer up the wall bracket.
•Fit the wall bracket to the wall and tighten the three screws firmly by hand, so the bracket is secured to the wall (and so the loudspeaker will not vibrate on the wall).
•Have your assistant insert the four screws with nylon washers, and loosely secure the loudspeaker brackets to the wall mount bracket.
•Adjust the tilt as desired, and then tighten the four screws securely.
•Test the loudspeakers and enjoy!
User's Manual |
| 9 |
|