Radio Shack TRC-494 owner manual Replacing the Power CORD’S Fuse

Page 34

21-1589.fm Page 17 Thursday, August 5, 1999 10:10 AM

REPLACING THE POWER CORD’S FUSE

The TRC-494’s 2-amp fuse helps protect your CB from power surges and short circuits. If the fuse is blown, replace it with a 2-amp, 250-volt, fast-acting fuse (Cat. No. 270-1052).

Follow these steps to replace the fuse.

1.Unplug the power cord from the vehicle’s cigarette lighter and be sure the CB is turned off.

2.To open the cigarette-lighter plug and remove the fuse, turn either end counterclockwise and release it.

3.If the fuse is blown, replace it.

Caution: Make sure you replace the fuse only with another fuse of the same type and rating.

4.To close the cigarette-lighter plug, put the open ends together, then turn either end clockwise.

17

Image 34
Contents TRC-494 TRC-494 Introduction Digital Channel-Number DisplayIntroduction FCC Information FCC Information Contents Contents Supplying Power PreparationPreparation Attaching Antenna Attaching the Antenna Directly to the CBAttaching Antenna Using the Antenna’s Magnetic Base Using the Antenna’s Magnetic Base Using the CB Using the CB Setting Range Setting Range Using the Weatheradio Using the Weatheradio CB Operation Tips Common Uses for a CB RadioCB Operation Tips CB Courtesy Maximum RangeCB Courtesy Using Common Codes Code MeaningUsing Common Codes Troubleshooting Symptom RemedyTroubleshooting Reducing Noise Reducing Noise Maintenance Maintenance Replacing the Power CORD’S Fuse Replacing the Power CORD’S Fuse Receiver SpecificationsTransmitter Specifications Fm Page 19 Thursday, August 5, 1999 1010 AM Fm Page 19 Thursday, August 5, 1999 1010 AM Radio Shack Limited Warranty Radio Shack Limited Warranty