| Multifunction Travel Alarm Clock |
www.radioshack.comSM |
|
OWNER’S MANUAL — |
|
Please read before using this equipment. | |
|
|
Large Display — Easily read all information at the same time.
Open the back cover and place up to 10 name cards in the holder.
| ¯ — Hold down to enter date and time setting mode . |
| Press while in time setting mode to store your settings. |
| ï — Press to set and store the alarm time. |
Photo Frame — Holds a 2.12 in. x 3.54 in. | SNOOZE/light/e — Press while the alarm sounds to |
activate the snooze feature. See “Using Snooze” on | |
(54 mm x 90 mm) picture. Pry out the | Page 2. |
plate. Remove the sample photo, place | Press SNOOZE/light once to view the time or |
the picture on the top of the photo frame, | temperature in the dark. The backlight shines for about |
and replace the plastic plate. | five seconds. Hold down SNOOZE/light to light the |
| clock display as long as you like. |
You can remove this label if necessary. | Press while setting the date, time, or alarm time to |
| scroll upwards. |
Repeatedly press ® to switch the temperature from Fahrenheit (°F) to Celsius (°C) format or vice versa on the display. The temperature is automatically updated every minute.
d/12/24 — Press while in time setting mode to alternate between
°/ON OFF — Press at any time to turn the alarm on or off.
Ô NOTE Ô
Your clock’s display is protected by a piece of film during shipping. Open the front cover and peel off this film before using the clock.
Setting the Date and Time
•When you set the date, the clock automatically sets the day of the week.
•To switch between the 12- and 24- hour time
formats, press 12/24. In the
•If you press ï, ®, or °/ON OFF during the time setting, the clock automatically returns to the previous setting.
•While setting the time or alarm time, if you do not press any key within 30 seconds, the clock returns to the current time/temperature display.
Thank you for purchasing the RadioShack Multifunction Travel Alarm Clock. It combines the versatility of a clock, picture frame, and name card holder into one convenient system. You can insert a picture into the frame to make a special keepsake. The 60- year calendar goes from 1990 to 2050. Ô
REMOVING THE BATTERY INSULATION STRIP
To prevent battery drain during shipping, your clock is shipped with an insulation strip that you must remove before use. Turn the clock over and pull up the back cover. Firmly grasp the strip end and gently pull it out. The clock beeps. 12:00 and the current temperature appear.
SETTING THE DATE AND TIME
1.Hold down ¯ until the clock sounds a long beep and the hour digits flash.
2.Repeatedly press or hold down e or d to set the hour.
3.Press ¯ to store the hour. The minute digits flash.
4.Repeat Steps 2 and 3 to set the minute,
year, month, and date. When you finish, the current time appears. Ô
SETTING THE ALARM TIME
You can set the clock to sound an alarm at a specified time.
1.Hold down ï until the clock beeps. 12:00 or the preset alarm time appears. The hour digits flash.
2.Repeatedly press or hold down e or d to set the alarm hour.
3.Press ï. The minute digits flash.
4.Repeatedly press or hold down e or d to set the alarm minute.
5.Press ï to store the alarm time. The alarm turns on and ï appears. At the preset alarm time, the alarm sounds for one minute then automatically turns off. To silence the alarm sooner, press any key (except SNOOZE/light).
6.To turn the alarm on or off at any time, press °/ON OFF. To turn off the alarm
when it sounds, press °/ON OFF twice. ï disappears.
! IMPORTANT !
If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon for pertinent information.
o— Warning | Ô — Note |
© 2003 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.