Lenoxx Electronics PDV-709 instruction manual FCC Note, Included Accessories

Page 3

SAFETY INSTRUCTIONS

Do not apply oil or petroleum products or solvents to any part of this set.

FCC NOTE

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation.

WARNING:

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect this equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

NOTE

This product incorporates copyright protection technology that is protected by method claims of U.S. patent numbers 4,631,603; 4,819,098; 4,907,093; 5,315,448; and 6,516,132 and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only, unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.

CAUTION

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. Do not open covers and do not repair yourself. Refer servicing to qualified personnel. This DVD VIDEO player is classified as CLASS 1 LASER PRODUCT as stated on the bottom of the set.

INCLUDED ACCESSORIES

The following items are included with your DVD player:

-Remote Control

-AAA Batteries (2)

-Rechargeable battery

-AC adaptor

-Car adaptor

-Audio/Video cable

-User’s Guide

-Product Registration Card

2

IB-PDV709-WM-E-061006

 

IB-PDV709-WM-E-061006.pmd3

8/3/2006, 11:00 AM

Image 3
Contents Portable DVD Player Blade Plug to Wide SLOT, Fully Insert Safety InstructionsFCC Note Included AccessoriesTable of Contents Front View Controls OverviewRechargeable Battery Rechargeable Battery For DC power supplyRight Side View Remote Control Direction buttons Used in DVD menusNumeric buttons Used in DVD menus Detaching the Battery refer to the diagram on the right Power SupplyTo charge the battery Attaching the Battery refer to the diagram on the rightRemote Control Operation Discs that cannot be played Discs that can be playedPlaying a Disc Search through a chapter or a track Using the Search FunctionsSelecting Audio Mode Changing Subtitle Language DVD onlyFor MP3 Play Displaying Disc InformationFor DVD Play For CD PlayFor CD Repeat PlaySLOW-MOTION Play Just for DVDPress Goto for CD Zoom Play for DVDSearch for Preferred Play Press Goto for DVDProgrammed Play Viewing Angle Shots DVD onlyJpeg or Picture Disc Operation 12. MP3 Disc OperationVideo connection S-VIDEO cable is not included Using the attached A/V cablesDiagram a Diagram BFor TV Connection System ConnectionsWatching a DVD on Your TV How to Find your TV’s Video Input ChannelSetting the LCD Mode Initial SettingSystem Setup TV SYSTEM, LCD MODE, TV Type & Default You can get to the Setup menu by following the below stepsDefault Resetting the functions to factory defaults LCD ModeSelecting the TV Type Language Setup On Screen Display, AUDIO, Subtitle & Menu Video SetupAudio Setup Digital OUT Only for Coaxial connection mode Precautions Symptom Remedy General Trouble ShootingSymptom DVD About DVD Region Management GlossaryDVD linear audio SpecificationsAudio Signal Output Characteristics General DescriptionDial For Customer Service