Lenoxx Electronics PDV-709 instruction manual Power Supply, To charge the battery

Page 8

POWER SUPPLY

You can power this portable DVD player by connecting the AC adaptor, the car adaptor or the rechargeable battery (all included).

A. Using the AC adaptor

This player is supplied with an AC adaptor for powering the unit and charging the battery.

Insert the AC adaptor plug to the DC IN jack on the portable DVD player and connect the adaptor to a wall outlet.

B. Using the car adaptor (12V)

This player is supplied with a 12V car adaptor for powering the unit and recharging the battery while in a vehicle that has a 12V power system.

Insert the car adaptor plug to the DC IN jack on the

portable DVD player and connect the car adaptor to the vehicle’s 12V accessory / cigarette lighter

socket, the car adaptor indicator will light up.

CAUTION:

1.The included car adaptor is for use with this unit only. Do not use it with other equipment.

2.Use this unit only with the included car adaptor, using with other car adaptors could damage the unit and the unit may not work.

3.Do not operate this unit or view video movies while driving a vehicle.

4.If some lines appear on the screen during the startup of the vehicle, please turn the unit off and turn it on again after the vehicle is running.

5.Place the unit in a proper position for viewing.

6.When the inside of the cigarette lighter socket is dirty with ashes or dust, the plug section may become hot or not work due to poor contact. Be sure to clean the cigarette lighter socket before use.

7.Disconnect the car adaptor from both the unit and the cigarette lighter socket when the battery is fully charged and the unit is not in use.

C. Using the rechargeable battery

The rechargeable battery pack is suitable for portable use which allows you to enjoy the unique functions of this unit outdoors.

Remember to charge the battery fully before

 

initial use (about 5 hours).

slot

Attaching the Battery (refer to the diagram on the right)

1. Make sure the player is off and the AC adaptor or car adaptor is disconnected.

2. Place the DVD player on a soft and smooth surface with the bottom of the unit facing up.

3. With one hand on the DVD player to prevent it from moving, take the battery and align the plastic tabs on the battery with slots on the player, and slide it forward to lock, The battery will click into place.

Detaching the Battery (refer to the diagram on the right)

 

1.

Make sure the player is off and the AC adaptor or car

 

 

adaptor is disconnected.

2

2.

Push the tab on the battery down.

 

3.

Slide and lift the battery out.

3

 

 

To charge the battery

tab

1.

Insert the AC adaptor’s plug into the DC IN jack on the DVD player and connect the AC

 

adaptor to a wall outlet. After 5 seconds, the battery LED indicator will turn on and start to flash.

 

7

IB-PDV709-WM-E-061006

IB-PDV709-WM-E-061006.pmd8

8/3/2006, 11:00 AM

Image 8
Contents Portable DVD Player Safety Instructions Blade Plug to Wide SLOT, Fully InsertIncluded Accessories FCC NoteTable of Contents Controls Overview Front ViewRight Side View Rechargeable BatteryRechargeable Battery For DC power supply Numeric buttons Used in DVD menus Remote ControlDirection buttons Used in DVD menus Power Supply To charge the batteryAttaching the Battery refer to the diagram on the right Detaching the Battery refer to the diagram on the rightRemote Control Operation Discs that can be played Discs that cannot be playedPlaying a Disc Using the Search Functions Selecting Audio ModeChanging Subtitle Language DVD only Search through a chapter or a trackDisplaying Disc Information For DVD PlayFor CD Play For MP3 PlayRepeat Play SLOW-MOTION PlayJust for DVD For CDZoom Play for DVD Search for Preferred PlayPress Goto for DVD Press Goto for CDViewing Angle Shots DVD only Programmed Play12. MP3 Disc Operation Jpeg or Picture Disc OperationUsing the attached A/V cables Diagram aDiagram B Video connection S-VIDEO cable is not includedSystem Connections For TV ConnectionHow to Find your TV’s Video Input Channel Watching a DVD on Your TVInitial Setting System Setup TV SYSTEM, LCD MODE, TV Type & DefaultYou can get to the Setup menu by following the below steps Setting the LCD ModeSelecting the TV Type Default Resetting the functions to factory defaultsLCD Mode Audio Setup Digital OUT Only for Coaxial connection mode Language Setup On Screen Display, AUDIO, Subtitle & MenuVideo Setup Precautions Trouble Shooting Symptom Remedy GeneralSymptom DVD Glossary About DVD Region ManagementSpecifications Audio Signal Output CharacteristicsGeneral Description DVD linear audioFor Customer Service Dial