NOTE
Remember, you cancel any scan mode at anytime by pressing the 16/9 or SCN key.
To start an All Scan
To scan through all available channels, press and hold the SCN key for three seconds. ALL SCN will appear on the display. The radio now will scroll through every available channel as it scans.
A noisy channel that interrupts the scanning can be temporarily elimi- nated from the scan list by holding down the MEM key. The channel re- ceiving the signal will be skipped, allowing the scanning to continue uninhibited. Turning the radio off and on again will restore all the channels back to the ALLSCAN memory list.
To start a Memory Scan
To scan through channels in the memory scan list, press the MEM key, then push the SCN key. If you are in a different scanning mode, you must stop the scan before switching to a MEMORY SCAN. In that case, press SCNMEMSCN.
To add channels to the memory scan list, use the ↑ ↓ keys to tune in each of the channels you want to monitor. As you tune in each channel, depress MEM for three seconds to add it to the memory list. The MEM Annunciator will appear, letting you know the channel has been added to memory..
While in the MEM scan mode, touch the WX key to toggle the WX ALERT function off and on. The scan will stop when a channel picks up a sig- nal. The scan will not continue until the input signal stops. To stop scanning, press the SCN key or the 16/9 key. Press in the PTT button exits the scan mode at the last channel display.
To start a Priority Scan
Pressing the SCN key activates the PRIORITY SCAN mode. P SCAN will ap-
26