P E N D I, Power UP Operation | JBL EVOi.net specification

A P P E N D I X

POWER UP OPERATION

There are two scenarios:

a)EVO Speakers have been changed/replaced or the speakers hook up configuration is different.

b)EVOi.net has been changed/replaced.

Because of the difficulty in reliably determining which is the appropriate scenario, the same procedure will be used in both situations, and will allow the user to go back to the alternative data set:

1.When powered up, the EVOi.net will download the data from the speaker and compare the EVO loud- speaker data with the EVOi.net stored data. If the data in the EVO loudspeakers does not match the data in the EVOi.net, the SPEAKER STATUS indicators will signify power-up disagreement error. Audio will not be allowed to pass at this time.

2.The EVOi.net will backup the data that came from the speakers to preserve it.

3.The EVOi.net will upload the original stored data into the speakers.

4.If the user is happy with this, any button press will clear the error, and unmute the system

5.To swap the data with the backed-up original speaker data, the press MAIN OUT SETUP 1&2, AUX OUT 3&4, and DELAY SETUP simultaneously to download the backed up EVO system data back into the EVO loudspeakers. This will back-up the original EVOi.net data, which the user can swap back to if required.

6.As a last resort the user may press the square LIVE AFC ON, EQ SELECT, and AEQ ON buttons simultaneously and restore the EVOi.324 settings to their original factory defaults.