JBL 2.4G AW Connections, Application, Adding speakers to remote locations around your home, Step

CONNECTIONS

Notes: For the sake of simplicity, throughout this manual we have used the term “source” when describing connections and operation. This would apply to any device such as an A/V receiver, audio component, computer or portable music player.

The JBL On Air may be connected to your source in several ways. First, determine how you would like to use the JBL On Air Control 2.4G AW; then follow the setup instructions for that application.

Application 1

Adding surround speakers to a home theater system. Continue reading the instructions for Application 1 below.

Application 2

Adding speakers to remote locations around your home.

Application 1

Adding surround speakers to a home theater system:

Determine if your source contains preamp outputs for rear/surround channels, usually indicated by RCA-type jacks on the back of the receiver labeled as “surround preout” (please refer to your source’s owner’s manual to confirm whether it includes the preamp outputs). If your receiver includes these outputs, follow the steps below.

If not, connection is not recommended.

NOTE: Make sure power is turned off on all components.

Step 1.

Connect the interconnect cable (included) to the left and right surround/rear preamp outputs on the back of your source and the input on the transmitter module , as shown in Figure 1.

RECEIVER/PROCESSOR

Surround Channel

Preamp Outputs

R L

ID

CODE

1 2 3 4 R INPUT L

Figure 1.

English

Step 2.

Determine the location of the surround speakers.

Subwoofer

Left Front	Center	Right Front
Channel	Channel	Channel

	Couch
Left	Right
Surround	Surround
Channel	Channel
	Subwoofer
	Right Front
	Channel
	Center
	Channel
	Right
	Surround
Left Front	Channel
Channel
	Left
	Surround
	Channel

Figure 2. Place the active (left) speaker in the recommended location for the left surround speaker.

5